The rod which releases the lefthand slider on my 2002 Pontiac Sunfire front passenger seat has come loose/dettached. I have the rod and the spring, and the seat currenty stuck all the way forward. I'm searching for an image of the assembly mechanism to aid in reattaching the rod and ensuring that no other elements ate obstructing movement.
SOURCE: 2000 pontiac emergency brake stuck. how do i
Are you in a Northern Climate were road salt is used during winter? The emergency brake problems I have encountered tend to be due to rust and corrosion accumulating on the wires and metal pivot points that operate the brake via the emergency handle on the center console.
Get underneath the car (chock the wheels---ALL FOUR! with bricks or large chunks of wood---be sure the car is in PARK!) and find the wire that connects to the handle of the brake---follow it to the rear brakes, and you will see a split where it goes to the L and R sides via a sliding clasp of steel that looks like a C, and has wires running over the top, and to each rear brake.
At this point, grab the wire on one side of it and PULL HARD several times, slack between pulls. Do this for each side---that should release the assembly, and the shoes from holding the drum.
After you have done this, lubricate the pivot points and the wire connection to the brake handle with TRI-FLOW (NOT WD-40)or another teflon based lubricant.
SOURCE: 1999 pontiac Grand Am Trunk release??
Under the front of the part of the seat (where your **** goes) remove the bolts that hold it there. You will then find bolts that hold the backrest in place. push backrest up and back to get it off.
SOURCE: Broken front lug bolt in 2002 Pontiac Sunfire.
Remove wheel, caliper and rotor. hit it solidly with a good hammer and it should go right through and fall out. Sometimes you will need to grind a bit off the side of the new one to get it past any obstructions. That will not harm its performance in any way unless you take way more than you need to off of it.To get it all the way back in, oil the threads, put a stack of large washers on it and tighten the nut on backwards till you draw it all the way in.
SOURCE: Hood release cable isn't connected to interior hood release lever
Your going to have to use vice grips or pliers. Just pull hard till you hear the hood pop open or have a friend push down on the hood so you can pull in the hood cable easier to unlock the hood latch. Good luck and keep me posted.
SOURCE: REPLACE SERPENTINE BELT ON 1997 PONTIAC SUNFIRE
give these websites a try www.alldatadiy.com and www.autozone.com and drive belt diagram www.webcrawler.com wish you the best of luck Michigan Man.if all fails stop by your local library and get your hands on a Haynes auto repair manual for your car.
127 views
Usually answered in minutes!
×