Question about 2000 Dodge Intrepid

Open Question

2000 Dodge Intrepid A/C won't work

I have a 2000 Dodge Intrepid 2.7L. The A/C won't operate properly at all. The blower motor speed control does it's job fine, but the Temp select and the Vent select knobs don't work correctly. When I turn the temp, NOTHING happens. When I turn the Vent, it change the Temp. I have replace the control box and the Mode Door Actuator. I am seeking help before I try to replace the ever-so-hard to get to Blend Door Actuator, which I was told may be it...but that's just the thing...it MAY be the problem. This cars A/C only comes out the defrost and the rear window defrost won't work. Someone, ANYONE, please help.

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
emissionwiz

Marvin

  • 85222 Answers

SOURCE: Blend door not working.

The bleed door controls air temp not where it comes out, dash, floor, defroster, this is most likely a mode control switch problem, that switch is on the ac control head.

Posted on Sep 23, 2008

Ad

Anonymous

  • 1 Answer

SOURCE: Ac/heating problem

Same problem for me. Local garage seems to think replacing the control module in the dash will solve the problem. I also have clicking sounds behind where the relay junction box is (under dash). My problem is intermitant so I'm also thinking that replacing a relay or two might also help.

Posted on Mar 23, 2009

moparownr

Jeff Hammack

  • 667 Answers

SOURCE: 2004 Ford Expedition XLT, front blend door actuator

Hope I was avle to help, glad you up and going.

Posted on May 27, 2009

chryslerguy

  • 323 Answers

SOURCE: heating / air conditioning control stuck to front defrost vents

There is a vacuum leak under the hood. Find the vacuum line on the passenger side where it comes through the firewall and follow it to the engine. You system needs vacuum to operate and without it the default setting is on defrost for safety reasons.

Posted on Jun 19, 2009

Anonymous

  • 86 Answers

SOURCE: Temp control on 99 dodge intrepid not working

try a new compressor or take it into the dealer

Posted on Jul 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have an 02 Dodge Intrepid whose blower motor will continue to run after I turn the ignition off.


Will the wipers also work with the ignition off? If so, possible ignition switch problem. If wipers don't work, suspect shorted blower motor resistor or controller

Sep 05, 2015 | 2002 Dodge Intrepid

1 Answer

My 99 dodge intrepid heater control stays blowing and wont light up and wont stop blowing unless i pull the fuse and nonew of the controls work


Are the different speeds working on the blower or is this stuck on just one speed ??? It seem as if the relay for the blower is fused together in the on position an can no longer be controlled by the switch. If this blower is not a relay controlled unit then most likely the blower switch is no longer working.

Aug 24, 2012 | 1999 Dodge Intrepid

1 Answer

Dodge intrepid


It could be the the fan motor relay if you replace the relay and it still doesn't work then its the blower motor needing to be replaced.

Mar 30, 2010 | 1997 Dodge Intrepid

2 Answers

A/c blower


replace fan control switch

Sep 12, 2009 | 1999 Dodge Intrepid

1 Answer

Temp control on 99 dodge intrepid not working


try a new compressor or take it into the dealer

Jul 27, 2009 | 1999 Dodge Intrepid

1 Answer

1999 dodge intrepid fan speed switch


your blower motor resistor is bad, it is a small electrical component located next to the blower motor under the dash, held it with two screws.

Apr 09, 2009 | 1999 Dodge Intrepid

1 Answer

98 Dodge Intrepid Blower stuck on high and no display.


Yes you car has something like a resistor but its called an ATC BLOWER CONTROL MODULE.Its under the dash on the pass side close to the firewall.

Feb 16, 2009 | 1998 Dodge Intrepid

1 Answer

2000 Dodge Caravan


if it is auto temp control the power module could be bad....if is regular style where you control blower speed the blower motor resister is bad

Oct 29, 2008 | 2000 Dodge Caravan

1 Answer

Heater / Air only work when blower is on set on high


You need to replace the blower speed control module, it is behind the glove box near the b;lower motor.

Oct 26, 2008 | 2001 Dodge Intrepid

Not finding what you are looking for?
2000 Dodge Intrepid Logo

Related Topics:

428 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...