Dodge intrepid On my 1997 Dodge Intrepid when I turn the fan blower switch on, all that happens is a soft clicing/buzzing noise, no activation of the fan motor. Is it the whole control switch behind the panel or the fan motor thats bad ?

Blower motor resistors are super common failures in these. The connector for it can also get melted.

Having to replace an ignition switch is common. The ignition switch is solid state so you cant fix it, it will need to be replaced.

the blower motor is under dash,behind glove box,there are three screws holding up.

check first if you are loosing water or cooling fluids on your radiator. There may be a leak or the radiator cap may no longer prevent the steam from escaping. check the radiator fans if they are turning. You can check the fan if it is working by removing the temp sensor at the lower radiator hose. The fan should turn on by then.

Does the engine turn over ? if not then check your battery/charging system....and check for anything that my have been left on or you may have some kind of a draw . if it does turn over then check for fuel pump activity by putting a hose down the filler neck and have someone turn the key to start...if you don't hear the buzzing noise of the pump turning then odds are it's your pump ...I hope this helps ...I can help you better if you describe exactly what the car is doing...is the check engine light on ? how well did it run before ? will it start up at all?

maybe the sensor that turns on the fans might of gone bad . . and turning on the ac when engine is gettin hot is not going to help instead turn on the heater to reduce the heat , also overheating causes hoses and gaskets to get soft and get destroyed

your blower motor resistor is bad, it is a small electrical component located next to the blower motor under the dash, held it with two screws.

have seen ignition switch cause all of these symptoms..also make sure connections at switch are clean and secure..

Yes you car has something like a resistor but its called an ATC BLOWER CONTROL MODULE.Its under the dash on the pass side close to the firewall.

I have a 96 Intrepid, and none of the signal lights work. I tried replacing the fuse, but this did not remedy the problem. Could this be a loose connection?