Change engine oil light is on i tried turning key to acc pump gas three times turned key off but light still comes back on

Place a piece of black electrical tape over it ,problem solved .you know the oil is good

Driver Information Center (DIC) Equipped

Step 1 of 5

Place the key in the ignition and then turn it to the On/ACC position with the engine off.

Step 2 of 5

Press the "mode" button on the DIC until "Oil Life Left/Hold Set to Reset" is displayed on the DIC screen.

Step 3 of 5

Press the "set" button and hold it down until "100%" is displayed on the DIC display screen.

Step 4 of 5

Wait until three brief chimes emit before turning the ignition key back to the off position.

Step 5 of 5

Start the engine of the Aztec to ensure the oil warning light ("Change Engine Oil") is no longer illuminated on the instrument panel. If it still is, repeat the procedure.

Non-DIC (Manual Change Oil Light)

Step 1 of 4

Insert the key into the ignition and turn it to the ON/ACC position with the engine off.

Step 2 of 4

Step on the accelerator pedal fully to the floor three times within five seconds.

Step 3 of 4

Turn the ignition key to the off position.

Step 4 of 4

Start the engine to ensure the oil warning light is no longer illuminated on the instrument panel. If it is,repeat the procedure.

• Hi, I can help.
• The service Engine Light Soon light means it's time for an oil change,

• You can turn this light off real quick by following these steps.

1. Turn the key to ACC.
2. Press the gas pedal down all the was three times in fairly rapid succession.
3. The service engine soon light will begin to blink and then disappear.
4. Turn the key to off.
5. now start your truck.
6. The light will now be off.

• This should be done after every oil change.
• All the light means is that the PCM has indicated that you have driven the required miles for an oil change. A reminder light if you will.

• If you have any comments please feel free to leave them here.
• Hope this helps and thank you for using FixYa.

Regards, Tony

turn the key on then pump the gas peddle slowly three times in 10 seconds turn the key off then start the engine. if the light comes back on .do the presager again.

Hello marco.... To reset the oil light do this. Turn on the key but do not start the engine. Pump the gas pedal hard three times in succession. Then turn the key fully on and start the engine. This will reset the oil light. It will come back on in about 3,000 miles as a reminder to change the oil. Joe

Thanks for choosing FIxya!

TRY RESETTING OIL CHANGELIGHT BY TURNING THE IGNITION SWITCH TO THE ON POSITION WITH ENGINE OFF.TURN IGNITION SWITCH ON 10 SECONDS PUMP ACCELRATOR SLOWLY 3 TIMES .UNTIL OIL CHANGE LIGHT FLASHES THEN IT HAS RESET.

it is done through the factory radio.

dont have factory radio?
1. turn the ignition key from Acc to on then back to Acc twice. 2. turn your head light switch on and off three times. This should reset the warning light. The change oil light can be reset by pressing on the gas peddle three times in place of the headlight switch.

turn the key as far as you can without starting it press the gas pedal 3 times all the way to the floor and shut the key off you have to do it all in a 5 second window so you might have to try a few times befor you get it if you dont turn the key off quick enough it wont work

Try this. With the key on and the engine not running push the gas peddle to the floor and release it three times then hold it to the floor until the oil light flashes. This should reset the oil indicator light. It should not take more than about 20 or 30 seconds.Good luck.

• its a sensor that lets you know to change oil. 1st turn key on start possession don't start, 2nd pump gas pedal three times fast not real fast then after the third time turn key back to off then start the vehicle this should reset the light!!