At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
I have a 2006 pt cruiser convertible. My window washer reservoir is full but will not spray onto windshield When completely full to top it works,but after a while it stops.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Push the windshield wiper lever forward to spray washer fluid on the rear window. The lever returns to its starting position when released.
The windshield washer reservoir is used for the windshield and the rear window. Check the fluid level in the reservoir if either washer is not working.
the pump which is located on the outlet of the reservoir is either defective, corroded/loose electrical wiring on it or a blown fuse. Check the fuse first seeing it the easiest. Hope this helps
CHECK THE SUPPLY TUBES FROM THE PUMP TO THE SPRAY HEADS. SOME TIMES FINE PARTICALS OF DIRT WILL STOP THESE UP REMOVE THE HOSE FROM UNDER THE HOOD AND USE COMPRESSED AIR AND BLOW FROM THE SPRAY HEADS BACK TO THE OPEN HOSE TO CLEAN OUT THE DIRT IF THIS DOSN'T WORK LEAVE THE HOSE OFF AND TRY THE WASHER WITH OUT THEM HOOKED UP SEE WHAT KIND OF FLOW YOU GET FROM THE PUMP IF IT IS VERY LOW THE PUMP IS BAD
If you have used ANYTHING beside windshield solvent in you reservor, you may have created WAXING from soap in the bottom of washer tank, which clogs pump,lines, and nozzel....take the tank out and wash it..disconnect washer hoses at nozzel and clear with compressed air along with the nozzel...if you use solvent only you may have a worn washer pump or restriction...check those and good luck.....
the pump wire is probably not making good connection with the pump that is why the washer fluid wont work try and clean the connection. the pump is located under the fill tank
check for a bad relay for the wipers not working. the relay will be under the hood or under the dash next to the fuses. the cover will tell you what piece is the relay. the relay controls the delay in the wipers so that is probably bad and you can get them at napa for cheap. and simple to install its just like a fuse.
×