Is there any certain order when reassembling an ignition on a 2007 gmc sierra 2500 hd sle? Im installing a new ignition starter switch and ignition lock cylinder and am not sure which should go in 1st.There is also a very large black wire/cable that clips in on the outside of the ignition block that looks as if it might effect the ignition starter switch on the inside of the housing. I also am not sure in which position the wheel on the starter switch and also the one inside where the cylinder fits in...I know its alot to address all at once but i gotta have EVERY question answered or im SOL! Help! Thanks!
SOURCE: i need to be walked
Here have information about #791 bypass module: Bulldogsecurity Model791
IF YOUR REMOTE STARTER IS CLICKING AND/OR
FLASHING THE PARKING LIGHTS AND IS NOT RESPONDING TO THE REMOTE, IT IS
IN SAFE MODE AND NEEDS TO BE INITIALIZED BY DOING THE FOLLOWING:
If you have a 4 button remote, you must ground the black/blue
hood pin
wire (raise hood if hood switch is installed). Apply 12volts to
blue/black brake wire (press and hold brake pedal if wire is installed).
Press and hold any button on your remote until clicking and flashing
stops. Unit will now respond to the remote. Remove ground from hood
pin wire and voltage from brake wire.
If you have a 2 button remote, hold brake and press any button on the
remote until clicking and flashing stops.
ADDENDUM
If
you have an RS1100 or RS1200 and
your vehicle runs for several seconds, shuts
off, restarts, runs, and shuts off again, perform
the following step:
Connect the Black/White tach wire (from the 16 pin plug) to the heavy
gauge White Ignition 1 wire and program the unit for Tach Mode (bottom
of page 19).
Witch model alarm have your vehicle?
Good luck.
Testimonial: "awesome info with lots of extras! went above and beyond the call of duty! "
156 views
Usually answered in minutes!
×