The ABS, TC and down hill descent lights on my Land rover are on. Why? how do i get it fixed

it depends whats leaking i think it has nothing to do with the problem you have abs,tc,and hill this means its a brake problem , wheel bearing ,speed sensor on the wheels or diff,could also be a trans problem but to do something quick unplug battery for 10-15 mins restart car drive for a while does light come back on

check wire that goes down to the hubs

i have same probleme with my land rover, this trouble is intermitant wath can i do abs light traction control andhill descent if you have he ansher for me [email protected] thank you

Read my post on landrover enthusiast comes under abs last resort lozzzz

Suggests either Wheel Bearing, ABS Sensor Fault, or Shuttle valve. Best to get it to a dealer and on the computer for them to diagnose what exactly is wrong.

unfortunately there is nothing that you can do, except take it to a land rover dealer to check with their tester, aftermarket code readers are not capable of reading land rovers. Hope this helps

you've got a bad wheel speed sensor or corresponding tone ring. take it to a dealer. they'll hook it up to a computer and tell you which sensor or tone ring it is and give you an estimate. you only pay for the hour of diag.

Hi no you can`t access the ABS unit with a MT 2500 snap-on machine you need dedicated software to get in to the ABS system on the Modis,the fault is usually as follows ,If you carefully take the centre console apart near the gearlever you will find the hill desent wiring is broken there are 2 wires that catch on the bottom of the linkage,when you have repaired them (make sure ignition off from start to finish of repair) If the wires are too short solder 2 same gauge extender wires in with heat shrink to protect them and then re-route the wires away from the linkage ,BE carefully as there are AIRBAG wires near there,the ABS lamp should go out when the repair is done if not you need to take it to a Landrover expert to diagnose further.

The hill descent switch wires have broken off on the switch.Pull down the gear lever cover and remove the micro switch ,solder the wires back on and refit.