2004 Jeep Liberty 3.7 liter 4 cylinder.clicking,tapping,wont cran

Tap them when the should be on. If they come on, replace them.

no job stated,
its not spark , 3.7L usa runs 6 COPS, all PCM fired direct
must be playing with what
CAMS
why not say the job, so we can be
ON THE SAME PAGE>?

if not in USA , now be like the time to say,no?
chapter 8 in service manual

posted VAST times,search much?

usa official, book. from jeep,not NET rumors.

Check Engine Light/Misfire Due to Intake Valve Locks ...

repairpal.com > Problems > Jeep > Liberty

Jeep Liberty Check Engine Light/Misfire Due to Intake Valve Locks/Valves. ...Misfire cyc 4 and random cyc misfires, changed coil packs and plugs... sounds as if rod ... Light came on again (misfire on cylinder 4) - switched coil from 4 to 2. Light ...

Jeep Liberty Questions - Cylinder Misfire code - CarGurus

www.cargurus.com > Questions > Jeep > Liberty

CarGurusMay 27, 2009 - #4 misfire new plugs and coil pack on #4 light came back on after 300 miles if ... How come it stopped misfiring for 2-3 months, and now is back? ... I have a 2005 Jeep Liberty 6 cylinder, engine light came on scaned the codes ...

Liberty Cylinder Misfire / Computer issue? - JeepForum.com

that's like a 3 page answer (and skim chapters, lots)
ill do step one,
disable air bags, first or maybe die.

alldata.com DIY log in and read. its there.
or
the real deal.
click jeep
https://www.techauthority.com/en-US/Pages/Home.aspx

I had that problem with my 2002 Jeep Liberty and the ignition switch cracked so I had that replaced. I am not sure if that is included in the ignition lock cylinder ...

tranny filter or engine filter, wow.

use a scan tool and scan, it then post the DTCs
problem never stated,

2003 JEEP LIBERTY 2.4L 4-cyl Engine Code [
Engine Oil Grade 1....API* SAE 5W-30 is preferred.
CAPACITIES:
Engine, with filter..........4.7 liters

2003 JEEP LIBERTY 3.7L 6-cyl Engine Code

Engine Oil Grade 1......API* SAE 5W-30 is preferred.

CAPACITIES:
Engine, with filter..........4.7 liters

Thank you for using fixya and good luck

if it clicks but power is good then the starter should be changed.

Wire on oil sending unit may have fallen off or sensor itself may have gone bad. Check both. If engine has no tapping noises, likely it's not a pressure problem.

Standing in front of your jeep and facing the engine. The number 1 cylinder is the one closest to you on your right (the drivers side of your jeep). The middle cylinder on the drivers side is the number 3 cylinder.

Driver Side Front to back is 1-3-5
Passenger side Front to Back is 2-4-6