When i press brake pedal my brake lights wont light up.i have turn signals and flashers but no brake lights.
Sounds like a brake lamp switch or fuse. Check all fuses electrically, with a test probe you can purchase from any auto parts store. Go through each fuse with the probe touching the end or tip of the fuse after clipping the lead on the probe to a good ground. If the probe lights up at both ends of the fuse, the fuse is sound, if it only lights up at one end then replace that fuse and if the probe does not light up at all, that fuse is not active so turn on the ignition but dont start the motor. The brake lamp switch is attached to the brake pedal. It may have a single wire or several. All the switch does is connect the brake lamp circuit to an active supply rail so, The switch should have one active wire and the other wire should become active when the pedal is pressed. If it does not, replace the switch. If it does, then you may have two blown bulbs in the rear lamps or a damaged wiring harness to the rear lamps and you should seek the advice of a qualified person. Start with the fuses, then the switch, then the bulbs..and remember, you may have more then one fuse panel in the vehicle so check under the hood too..
Where on the pedal is it located i can't seem to find it
Replace the brake light switch on the brake pedal.
492 views
Usually answered in minutes!
×