At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
My 05 Dodge Ram Hemi 1500 4x4 wouldnt start today. It would turn but not start. it took like 10 tries for it to finally go. There are no engine codes showing on the dash. Two weeks ago I changed the plugs, cleaned the throttle body and changed the EGR and it ran fine. The EGR was changed because of random stalling.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
https://dodgeforum.com > ... > 3rd Gen Ram Tech
I cant find my orifice tube location a 2007 dodge ram 1500 with a 4.7 engine. Might be better to put this in the 3rd gen Ram forum instead of 2nd gen Dakota.
Could be the master cylinder has gone, if you took the brake line off then you will have to bleed the brake system and that should fix it, you also need to backup and press the brakes so that the pads and piston seat into place but just go slowly and not very far, 10 feet maybe.
P0301-P0308....2T catalyst........2004-05 Ram...Cylinder 1-8 Misfire Detected Conditions: Any time engine is running and the adaptive numerator has been successfully updated. When more than 1.5% (300M, Magnum), 2% (Durango, Ram), 2.5% (Durango LEV, Ram LEV), misfire rate is measured during 2 trips, or with 10-30% misfire during 1 trip. 3 good trips required to turn off MIL. Possible Causes: ASD relay output 2 circuit fault Injector control 1 circuit fault Coil control 1 circuit fault Ignition wiring, spark plug, or ignition coil fault Fuel pump inlet strainer plugged Restricted fuel supply line Fuel pump module fault Fuel pressure leakdown fault Fuel injector is damaged or has failed Engine mechanical problems exist PCM has failed. Hope this helps you. Thank You for using fixya.If you like this solution please rate it....Thank You, iluv2fish....Ray
hmmm, I had same problem, but engine light flashed a code.....turn key on and off without starting, leave in the on position on third time, you will see codes come up if you have any where the milage is displayed. Mine turned out to be the EGR valve was stuck. Had it replaced at dealer, was lucky...under warranty.
×