Where are the starter bolts located? 1994 Olds Ciera S w/v6

I really needs checking against the spark plugs you have chosen? .045" is about right for most.

1989-1996 Oldsmobile Cutlass Ciera 3.1L 3.3L V6 6 pc NGK ...

https://www.sixityauto.com > 6-pcs-ngk-v-power-spark...
This 6 pack NGK V-Power Spark Plug fits your 1996, 1995, 1994, 1993, 1992, ... 1989, Oldsmobile, Cutlass Ciera, 3.3L V6;Gap 0.060";Oe Equivalent Design ...

• 
  

  1987-1995 Oldsmobile Cutlass Ciera 2.8L 3.1L V6 6 pc Champion ...

  https://www.sixityauto.com > 6-pc-champion-copper-sp...
  6 pc Champion Copper Plus Spark Plugs for 1987-1995 Oldsmobile Cutlass Ciera 2.8L ... 1988, Oldsmobile, Cutlass Ciera, 2.8L V6;Plug Type Rs15Lyc; Gap 0.045"

What is the Spark plug gap on 95 olds cutlass Cierra? - Answers

https://www.answers.com > What_is_the_Spark_plug_g...
Aug. 4, 2007 - Standard gap is .060" or 1/16".Ask at auto parts counter when purchasing spark plugs. What is the 1972 olds cutlass 2 barrel spark plug gap ...

You should have two or three wires that go to the large post on the solenoid, including the 4 gauge wire from the battery. Then one 16 gauge wire to the small post. That wire comes from the key switch.
Let me know if you need colors for wires.

1 2 3 4 5 6 if its a 3.1L with an "M" in the vin code. Olds had the 3.1, the 3.4, and the 3.8L V6 engines that year

REMOVE THE STARTER FLY WHEEL COVER. STARTER BOLTS IS VERTICAL BOLTED INTO THE ENGINE.

Follow the top radiator hose. Where it connects to the engine, there is a thermostat cover. Remove the two bolts and the thermostat is under the cover.

There are only two bolts holding the starter in place and a small bracket.

should be behind the bottom pulley(harmonic balancer)(crankshaft pulley).You will have to remove the bolt in the pulley first,to do this.You will have to remove the starter or there might be a small shield where the tranny and engine attach.This will give you a way to hold the engine so you can remove the bolt.I use an old main bearing and put in the teeth on flywheel.once bolt out You will have to get a 2 or 3 jaw puller and pull the pulley off.

Hello. Here are the steps. Disconnect the - battery cable
Raise and support vehicle
Disconnect wiring at top of starter
Remove starter mounting bolts
Remove starter.
You can go to many auto parts stores these days and borrow the tools you need. good luck.

Hi
Fit the torque convertor to the gearbox first, make sure it locates fully with the pump drive on the g/box(the round section that's got two flat sections) in the centre of the bellhousing. Make sure the convertor does not slip out when mating engine and g/box, when mated there should not be any gap between engine and g/box(transmision) without any bolts tightened, secure transmision to engine then only replace the bolts that holds the torque convertor to the flexplate.

Regards
Phillip

take off the top hose then remove the houseing it should have 2 -4 bolts after you remove them pull out the thermostat this is on a v6 or v8 let me know what you have if you would