Question about 1995 GMC Jimmy
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: 2004 tahoe
make sure than you have not split any fluids on the passenger front door most of the times is where the module to control the windows and doors is located, try by unpluging the batterie and the after a minute plug it back and see what happend but if any of your ft doors have been split with liquid or rain has gone inside then most likelly the module got moisture and not working
Posted on May 31, 2008
if fuses chk.out ok i would have to say its the drivers side controls went bad. windows, door locks, everything runs thru drivers controls. even though you said buttons chk. out ok i can't think of anything else other than a fuse, unless the wires came loose from the maine controls or maybe there coroded. hope i've ben some help. OLD SCHOOL.
Posted on Jan 14, 2009
This could be a problem with your primary switch in the driver's door. Everything passes through that switch. Verify voltage continuity to the switch (Haynes or Chilton will give you a conclusive wiring schematic), and you must also verify that the switch itself is not faulty. Using a DMM (digital multi meter), measure the resistance (ohms) between 2 contact points, then hit the switch and verify that this number increases.
Posted on Aug 07, 2009
I have been dealing with the same problem and I'm a little further than you are. You need two people to do this job. Open the front door and it will give you access to the hinge pin. If I remember correctly you can pop off the snap rings and pull the pins. This will allow you to open the door just enough to get the interior panel off the door to allow you access to the actuator. Unfortunately, both my rear door actuators have been done twice in the last 5 weeks, But they are seized in the locked position again. I,m pretty sure its not just the actuators that are bad. Something else is causing this and that is why I'm here. Good luck with that one.
Posted on Aug 28, 2009
Tips for a great answer:
Mar 07, 2018 | Chevrolet Blazer Cars & Trucks
Nov 29, 2017 | 2002 Chevrolet Blazer
Sep 27, 2010 | 2001 Chevrolet Blazer
Jul 26, 2010 | 1996 Chevrolet Blazer
Apr 18, 2010 | 2000 Chevrolet Blazer
Dec 14, 2009 | 2000 Chevrolet Blazer
Dec 04, 2009 | 2000 Chevrolet Blazer
Jul 15, 2009 | 2000 Chevrolet Blazer
Mar 22, 2009 | 2000 Chevrolet Blazer
113 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: