1991 Accord: I have a 1991 honda accord ex and after the hoses ...

on the water housing on the cylinder head

I have a 1993 honda accord ex that leaking water behind engine near my oil filter it was leaking water above it How do I fix the hose show me how

Follow top radiator hose to engine, The neck the hose connects to is the thermostat housing, Remove the bolts and replace as needed

The thermostat is usually located at the lower radiator hose inlet to the engine, that is where you will find the thermostat housing to remove the thermostat.

Remember that the spring end of the thermostat should always go towards the engine, and not towards the radiator hose.

Follow the LOWER radiator hose from the radiator to the engine. Where it meets the engine is where the thermostat housing is.

remove the hose ...this is to the radiator correct just make sure the motor has not been Running or you will get burnt also use a pan to collect the antifreeze and refill the radiator

MOST HONDA STARTERS ARE AT TOP OF TRANS MISSION BACK SIDE HOPE THIS HELPS UNDER HOOD

where those hoses are is the thermostat housing

change your fast idle thermo valve

you need to follow the upper hose that lead from the radiator to the engine, there is two bolt that connect the thermostat housing to the block loosen the bolt using a 10 mm socket with ra-chet. Make sure that the engine is cool off before attempt to do this you will lose coolant but that's ok you will add the coolant when you finish replacing the thermostat. start the engine with the radiator cap off then add coolant slowly and cap it, then fill the reservoir up.

note the way you remove the thermostat that's the same way you will put the new one so pay attention when you remove the old one good luck.