Have a 2005 Dodge Grand Caravan SXT and the Drivers side window keeps getting stuck in the up position. I unbolt the motor and the tension gets released and it works for a few times. Every time I do this the motor is hot and I have tried lubricating the tracks. Do I need to replace the motor? .

SOURCE: Remove inside panel pass.side door of 2001 Dodge gr.caravan sport

1, Disconnect the able from negative terminal of the battery.
2. Pry the courtesy light from the door trim and disconnect the wire connector..
3. Remove all door trim panel retaining screws and door pull armrest assemblies.
4. Remove the door switch panel and the control switch panel and the control switch assembly.
5. On models with memory seats/mirrors, use small-flat bladed pry tool to remove and disconnect the wire.
6. Grasp the trim panel lift up and pull out to detach it from the door. Disconnect the inner door handle lock rod from the handle. Unplug any electrical connectors remaining and remove the door panel.
7. To install, connect the wire harness connectors and place the panel in position in the door. Press the trim panel down into place until the hooks are seated.
8. Install the armrest/door pulls, the courtesy light and the window switch'
9. Reconnect the battery


Also. You will need star pattern drivers to remove the window and motor from your door. If you have all the equipment it should only take you 1 hour.

Greg Bernett

• 2993 Answers
• Posted on Mar 12, 2009

SOURCE: i need to change the alternator on my 2000 dodge

I have to use a 15mm open/closed end wrench on the tensioner pulley. Use the closed end of the 15mm and pull toward you and use the end of a cresent wrench to use for additional torque. You can slip the belt over the fixed pulley (not the tensioner pulley). Give yourself more room by not using the hood bar and use instead a broomstick on the right side to prop the hood open. I recommend a goodyear gator belt too. Good Luck, you'll need it with a caravan. Its on the left side. its the easyest pully to see.

http://www.autozone.com/images/cds/jpg/small/0900823d8010b6d6.jpg


http://image01.shopzilla-images.com/resize?sq=140&uid=762102759

Hope this helps and please don't forget to rate.

SOURCE: 2005 dodge grand caravan getting code p0406

3.3 engines has the egr valve with transducer.you have to replace the whole unit. code p0406 what its trying to tell you your egr valve circuit is short to ground.it has failed .

SOURCE: Does a 2005 Dodge caravan SXT have

If it a 2.4L I-4 Eng it has a timing belt @ 100-125K Change. On 3.3 , 3.8L V-6 it has timing chain @ 175-200K change

SOURCE: replacing serpentine belt on 1996 Dodge Grand

This is the procedure for 3.3 and 3.8L engines:

1. Disconnect the negative battery cable.
2. Raise the front of the vehicle and safely support it with jackstands.
3. Remove the right front splash shield.
4. Release tension by rotating the tensioner clockwise.
5. Remove the belt and install a replacement.
6. Proper belt tension is maintain by the dynamic tension.
7. Install the right front splash shield. Lower the front of the vehicle.
8. Connect the negative battery cable.