Cars & Trucks Logo

Related Topics:

Anonymous Posted on May 22, 2010

I have a '56 victoria with an '87 LTD crown victoria 5.0L 302 engine, after starting the car and letting it run about 5 to 10 mins, it starts making this loud cranking noise, I have it pin pointed to it coming from the fan or near it! I don't have a clue to what it is, or if it is something inside the fan? plz help! -Thanks Kevin

1 Answer

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

  • Master 2,309 Answers
  • Posted on May 22, 2010
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

Joined: Oct 26, 2009
Answers
2309
Questions
0
Helped
625255
Points
7277

Does it have a clutch fan??? sound like its going bad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

Where is theEMC on a 87 ltd 302 fi crown vic and what happens when it goes bad?

The ECM is located under the dashboard.
Try this before you replace the ECM change the pick up coil in the distributor the symptoms you are having usually happens when the pick up coil get hot and is defective. Here's how disconnect the battery, remove the distributor cap and you will see a disc like object below the rotor. It may have two or three screws holding it in place remove them and then remove the pick up cool. They start at $24.99
0helpful
1answer

Why won't my 1984 ltd crown victoria hold it's idle when the 302 engine is hot?

When was the last tune up? There is a few things that come to mind. possible low fuel pressure, dirty fuel injector, throttle body could need cleaning, dirty fuel filter, water in the fuel, spark plugs need to be replaced or re gapped. I need more information to try to be more helpful.
0helpful
1answer

How do you depressurize the CFI on 85 Crown Victoria LTD?

1. Start engine
2. allow to idle
3. remove fuel pump fuse while engine running
4. with fuse still removed restart 1-3 more times to clear any fuel from system.
System D/P'd.
0helpful
2answers

Starts and runs fine for about 10 min. then runs rough then stops running

Idle air control valve and possibly the throttle position sensor contacts are worn the both of them expand from heat and break contact but try first using carbon conductive grease on the plug contacts there could be oxidation or corrosion in them causing the problem before you start spending $$$$ you spent big money already with no result ?good luck stephen
0helpful
1answer

Where can I find a Ford Windsor 302 for a 1985 Crown Victoria LTD Coupe?

You can order a remanufactured engine from any NAPA or Carquest auto parts store (my 1st choice for quality), there are many other sources including Autozone, Advance auto parts and many more. Expect to pay about $1800.00+rebuildable core charge.
1helpful
3answers

I am changing spark plugs on a 199- Crown Victoria. I don't know what the gap is supposed to be, can you help?

Make: FORD
Model: LTD CROWN VICTORIA
Year: 1991
Engine: V8 - 5.0L - FI - - GAS

part Number: RS14LC
GAP: .050" (Original Equipment Manufacturer and/or Original Equipment Equivalent)

Hope this helps (remember to rate this answer).
0helpful
1answer

Would you please let me know where the PVC valve is located on a 1990 Ford LTD Crown Victoria (5.0 liter engine)?

The Positive Crankcase Ventilation valve is in the valve cover. It sticks up a bit, and has a hose running to it.
0helpful
1answer

I have a 90 Crown Victoria. Do I need to have

This depends where you live ,but in most large meto areas you must pass the emissions test set by your state and they get this from the federal gov't.I you live hopefully some where that emissions testing are not required your vehicle should run just fine with out what your talking about,but please note that it is illeagle to take off any part of your factory emissions system.The fed's and the state are very strict on this the fine are huge ,much cheaper to fix what is broken if this is the case.The Crown Vic's mostly came with 5.0 -- 302 engines that just run forever 1 of ford's best motors they ever built.Good luck I hope this helps ya out .
1helpful
3answers

1987 crwn vic 5.0 l, 302, Engine runs for 5-10 minutes and shut down. Cranks but will not restart. After 12-24 hrs car will start again and run for 5-10 minutes and process repeats. When the car shuts off...

this is tough, two things I can think of, the first is the coil, if it is not ground good there wont be a good spark or a defective coil,,,, but i am leaning more to it being the timing chain jumped a cog,,, the computer would start the engine advansed but as the engine warmed it would ****** the spark ,,, after 5-10 min. it would quit,, this I would if it si a higher milage car. Tony
1helpful
1answer

Engine does not start immediately when cranking

The problem could be many things. Is the engine light on? Check for proper fuel pressure. Remove one spark plug and inspect. Your vehicle may just need a simple tune up. Spark plugs,distributor cap and rotor,fuel filter.
Not finding what you are looking for?

203 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...