Driver side door panel - 1999 Jeep Grand Cherokee

SOURCE: how do i remove the drivers side door panel? need to access wiring to replace the drivers side mirror.

how do i replace the side mirror on 94 acura integra

SOURCE: removing door panel drivers side to connect mirror wiring behind this panel

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

SOURCE: driver side door panel removal

Generic instructions to remove door panels:

1. Remove the screw(s) in the trim behind the door release handle and remove the trim.
2. Look for the screws in the arm rest and remove. Remove the arm rest.
3. Look for other screws (possibly under caps) and remove them.
4. Insert a wide flat blade between the door panel and the door. Find the plastic tabs which hold the panel to the door and gently pry the panel away from the door. Make sure you work as close to these plastic tabs as possible to avoid ripping the panel.
5. Work your way around the door prying the tabs out of the door.
6. When everything is free, gently lift the door panel straight up and out of the door.
7. Disconnect the electrical wires, and you are done.
8. There is a vapor barrier between the door and panel which must be gently peeled out of the way in order for you to gain access to the window and door latch mechanisms.

SOURCE: need to remove driver side door panel?

1. Disconnect the negative battery cable.
2. If equipped with an accessory switch panel, carefully pry the switch panel up and away from the door panel. Tag and disconnect the switches from the panel.
3. On 1981-86 models, remove armrest attaching screws.
4. On 1987-96 models, remove the retainer screws secure the pocket in the molded armrest on the door panel.
5. If equipped with crank type windows, remove window crank handle with the appropriate clip removal tool.
6. If equipped with manual remote mirrors, remove the control knob bezel.
7. Remove inside door handle cover attaching screw and trim plate.
8. If equipped with door mounted speakers, remove the speaker, and disconnect the speaker wires. For speaker removal and installation steps, refer to .
9. Remove all external screws securing the door panel. Insert an appropriate prytool between the door panel and door frame to remove the hidden clips securing the panel.
10. Holding door panel vertical lift straight up to release the upper clip.
11. Inspect all retaining clips and replace any broken or missing pieces.

1. Position the door to the door and carefully press on the retainer clips to engage. If a clip will not engage, inspect the mounting hole behind the panel to make sure the clip is properly aligned. Install any panel-to-door retainer screws.
2. If equipped with crank windows, attach the washer and crank to the window regulator stud.
3. On 1981-86 models, attach the armrest to the door using the retainer screws.
4. On 1987-96 models, insert the armrest pocket and secure in place with retainer screws.
5. If equipped with door panel mounted speakers, attach the speaker wires to the speaker and secure the assembly to the door panel.
6. If equipped with remote cable mirrors, attach the control knob to the door panel with the retainer bezel.
7. If equipped with an ashtray, insert the holder assembly, and secure in place with retainer screws. Install the ashtray to the holder assembly.
8. Position the door handle trim panel around the door handle assembly, and secure in place with the retainer screw.
9. If equipped with accessory switch panel, attach the harnesses to the switches, and press the accessory plate into the door panel.
10. Connect the negative battery cable.
11. Check and make sure all panel components function correctly.