A drive cycle is not measured in miles driven but in the type of driving done, here is a ford drive cycle procedure to clear the not ready code.
Ford Motor Company Driving Cycle
Description of OBDII Drive Cycle
The following procedure is designed to execute and complete the OBDII monitors and to clear the Ford P1000, I/M readiness code. To complete a specific monitor for repair verification, follow steps 1 through 4, then continue with the step described by the appropriate monitor found under the "OBDII Monitor Exercised" column. When the ambient air temperature is outside 4.4 to 37.8°C (40 to 100° F), or the altitude is above 2438 meters (8000 feet), the EVAP monitor will not run. If the P1000 code must be cleared in these conditions, the PCM must detect them once (twice on some applications) before the EVAP monitor can be "bypassed" and the P1000 cleared. The Evap "bypassing" procedure is described in the following drive cycle.
The OBDII Drive Cycle will be performed using a scan tool. Consult the instruction manual for each described function. NOTE: A detailed description of a Powertrain Control Module (PCM) Reset is found in this section, refer to the table of contents.
Drive Cycle Recommendations:
WARNING
STRICT OBSERVANCE OF POSTED SPEED LIMITS AND ATTENTION TO DRIVING CONDITIONS ARE MANDATORY WHEN PROCEEDING THROUGH THE FOLLOWING DRIVE CYCLES.
For best results, follow each of the following steps as accurately as possible:
Generally 50
SOURCE: What is the 1998 Ford F150 Drive cycle - how many
IT IS NOT A CERTAIN NUMBER OF MILES
READ THE TEST DISCRIPTION AT THE WEB LINK BELOW, FOLLOW IT TO THE "T"
http://www.obdii.com/drivecycleford.html
A service technician will
turn off the dashboard "check engine" light after most repairs. This
resets the vehicle's emission system components to "not ready". The
status remains "not ready" until the vehicle's computer has had adequate
time to review the repaired component. This happens after the vehicle
is driven for a period of time established by the manufacturer.
If the vehicle's emissions system status is "not ready" when it is presented at the E-Check station during the initial test cycle,
a tailpipe emissions test may be conducted. If the vehicle is
transferred to another test type, the vehicle must remain on the
different test track until the vehicle passes the emissions test or
receives a waiver. For example, if the vehicle undergoes an OBD II test
and fails, it cannot be downgraded to a tailpipe test on a re-test; the
vehicle must pass the OBD II test.
For initial and subsequent tests, if a dashboard light is on when the vehicle is presented at the E-Check station, the vehicle will fail the test.
How can the vehicle status be made ready?
When a vehicle is driven through its normal drive cycle, the computer reviews the emission control
system and if the vehicle was properly repaired, the system resets itself to ready. A normal drive
cycle includes operation at both cruising speeds and in stop-and-go traffic for up to a couple
weeks. This process should be followed before bringing the vehicle in to be tested.
7,948 views
Usually answered in minutes!
×