OLDSMOBILE ALERO 1999 MY KEYS ARE LOCKDED IN THE TRUNK...HOW DO YOU LIFT THE BACK SEAT

Hello ... There should be either two bolts at the bottom of the padded part that go through either a tab flush with the metal floor or the metal that face the trunk. sometimes after you remove these bolts you have to press in firmly either close to the top or middle of the padding and lift towards the roof at the same time . I used to put my shoulder against it and lift at the same time and it would come out . They can be stubborn by times so be sure to apply lots of lift and push at the same time .. That is the way I got the last one out but things change fast and I could be wrong . No harm in trying . Some times the bolts at the bottom are covered by mat or a sealing paper so have a good look first . If it has a split seat that's likely not the way it comes out . Some times you can find the fasteners by sliding your hands around the outer edges too . Hope that helps .

Cutting Fuel Pump Access Panel and Removing ... - YouTube

? 13:28
https://www.youtube.com/watch?v=COOLesyiVNc
Sep 16, 2013 - Uploaded by JEG's Garage
This is some shots of me making my access panel for my fuel pump in my 86 Trans AM. The fuel tank is a 2002 plastic fuel tank. You'll notice ...

Oldsmobile Alero access fuel pump trunk Questions ... - Fixya

www.fixya.com > ... > Cars & Trucks > Oldsmobile

Oldsmobile Alero cars & trucks access fuel pump trunk questions and ... Some cars have an access panel in the trunk under the carpeting, near the back seat on the ... is there an access to the fuel pump beside dropping the tank not unless you cut a ... ...no access hole you have to take the fuel tank out to replace the pump.

You may either need a new trunk latch, or if you have a remote opener for your car, the button on it to open the trunk may be pressing against something in your pocket or purse (on the way in or out or once its stored) if that's where you keep it.

LIFT THE REAR SEAT BOTTOM CUSHION UP SHARPLY AT THE TWO FRONT CORNERS UNTIL THE TWO CLIPS COME OUT OF THE BODY,THEN SLIDE THE SEAT CUSHION FORWARD AND OUT OT THE VECHICLE. AT EACH LOWER CORNER REMOVE THE NUTS SECURING THE TWO REAR SEAT BACK TABS WITH THE NUTS REMOVED PULL THE SEAT BACK FORWARD ENOUGH FOR THE TABS TO CLEAR THE STUDS THEN PULL THE SEAT BACK SHARPLY UP AND TOWARD THE INSTRUMENT PANEL TO DISENGAGE THE UPPER SEAT CLIPS FROM THE BODY.REMOVE THE SEAT BACK FROM THE VECHICLE.

sometimes that can b tough but is how they come out try puting presure on it and tape one side ov bottom at a time with a block ov wood about 1 foot in from side left and right remember keep as much presure as ucan and lift up when someone taps this may help good luck gordon

THE OLDSMOBILE ALERO DONT HAVE A EXTERNAL ANTENNA MAST. THE OLDS ALERO HAVE WIRE GRID ANTENNA INCORPORATED INTO THE DEFOGGER GRID IN THE REAR WINDOW.THE GRID ANTENNA HAVE A REAR WINDOW ANTENNA MODULE MOUNTED BEHIND TOP OF THE REAR SEAT BACK. THE RADIO ANTENNA CABLE GOES TO ANTENNA MODULE LOCATED TOP OF THE REAR SEAT BACK.

CHECK TRUNK FUSE AND RELAY ON THE INSTRUMENT PANEL FUSE BLOCK ON DRIVER SIDE ON SIDE OF DASH PANEL.IF FUSE RELAY OKAY THE TRUNK ELECTRIC OPEN SOLENOID SWITCH BAD.THE THEFT SECURITY HAS TO CHECK AT DEALERSHIP.MOST TIME WHEN YOU HAVE TROUBLE WITH IT.YOUR KEY OR SWITCH WORN ALSO BCM CONTROL MODULE.IF DEALERSHIP FIND FAULT IN THE THEFT SECURITY SYSTEM THEY HAVE TO FIX IT AND REPROGRAM IT.NOT A HOME FIX.

TO REMOVE TRUNK LATCH YOU HAVE TO DISCONNECT TRUNK LATCH CABLE FROM LOCK CYLINDER END.THEN YOU MARK TRUNK LATCH RELATIONSHIP TO THE TRUNK LID AND DISCONNECT THE ELECTRICAL CONNECTOR AT THE TRUNK LATCH.REMOVE THE LATCH RETAINING BOLTS AND REMOVE THE LATCH.PUT EVERY THING BACK VISA VERSA.

I'm going out on a limb here ... is there no remote control access on your key fob? no switch in the glove box ... no opener on the driver side door?

Remove the seat by first pushing the bottom front of the bench part to the rear of the car to unhook the latches, lift it up ... remove the bench. You will then find two bolts ... one on each side of the seat back ... remove them and the seat back should come out ...

Thanks for your interest in FixYa.com

If your trunk release button is electric, and not working because you need to turn the key to give it power, remove the button and use a piece of wire to jump power to it from the battery. This will get your trunk open! (don't forget to have a spare key made)