At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
I am replacing a fuel pump for a 1998 s10, i took the old one out and put the new one in the connection is differnt, i think i hook it up right, but i cant get the pump to come on
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I would recheck the wire hook up at the fuel tank. Usually when you replace the pump in the tank they should have given you a new fuel pump connector. You probably have a bad contact at this small harness.
98 chev pickup s10 put gas in the gas tank drove it about 2days and the check engen light came on had it check mech said it was the gas cap replace the gas cap the light back on now what help
if u took the bed off make sure the ground is hook back up to the frame that should allowed the pump to come on.need to change the fuel pump relay when changing fuel pump,that could be why the pump stop working before u change the old pump.
The rubber ring goes between the tank and the pump/sending unit flange. There should be a nothc on the tank and a corresponding tab on the flange of the pump unit, to ensure correct orientation. Set the lock ring over the flange, and tap in clockwise with a NON_SPARKING drift. The ring will cam lock into place.
replaced your fuel pump and when you buy it make sure to replace the oil sending sensor on the fuel pump it comes with a replacement when you purchase a new fuel pump
The FUel Pump only Recieves power for a few seconds when you cycle the key and should be on during crank. I would also make sure the injectors are pulsing by hooking a noid light or a regualr test light to each side of the 2 wirs and check for flashing during crank. Just get it running before you worry about guages. If the fuel guage quit after the pump than either the sender/float got screwed up or it is a wiring issue right above thak or at the connector
i recently did my chev s10 and they give you a new wire harness that you have to splice the wires and hook them up so it now has the same hook up. those wires are for your gauge as well as your pump. if your sending unit was not hooked up you would not go any where..take it back and demand this gets fixed.
×