SOURCE: how to remove the ignition switch in a 1993 Jeep Cherokee?
The ignition switch or the key cylinder?
SOURCE: how to remove the ignition switch in a 1993 Jeep Cherokee?
you need to remove steering wheel and you will see how its done once you get inside
SOURCE: 2006 Jeep Wrangler won't start
First, make sure you can turn the engine by hand. If you can't then the starter can't turn it either. Have someone else turn the key and look for the source of the click...may be a relay. Go over the starting circuit with a volt meter. Check for power at the starter main terminal and then with the key turned to "start" check for power at the trigger terminal on the starter. Check battery voltage and check relay operation.
You have a neutral safety switch on the transmission if its an automatic and a clutch switch if it's a stick. Check them as well. Make sure battery grounding on fender and block are also clean and secure.
Testimonial: "Will try! Thanks!"
SOURCE: 2000 jeep wrangler will not start from the key
It sounds like you have a bad neutral safety switch or your linkage is worn enough that it's not registering properly.
544 views
Usually answered in minutes!
×