I was driving my 1996 chrysler grand voyager and it sudenly just died, it is a 3.3 gassolin engine with autmatic.
The fuel pump goes, If I wait a while the car starts but dies, does not get fuel to the engine.
what can it be, can it be the fuel filter is blocked ?
You should check out www.reliable-store.com they have info on repair, service, wiring diagram, electrical diagram, fuse diagram, troubleshooting, PCV,
owner's/service/repair/parts manual, fault codes, error codes, etc everything on all vehicles. must check it out
SOURCE: heating doesnt work - no hot air in chrysler grand voyager
(check water/ antifreeze level first, make sure it's full, low water can cause it not to heat properly) it could possibly be either the thermostat- fairly cheap and easy to fix, great for DIY's- if that doesn't fix it, it could be heater core.
SOURCE: serpentine belt chrysler grand voyager 3.3l 1997
http://www.mvreader.com/multiview/dayco/catalogSearch.php?autoCatalogSearch=1&make=CHRYSLER&model=TOWN%20%26% The Town and Country has the Exact same Motor, Here is the Link to the 3.3 Liter Belt Diagram. It is the First at the Top, Just read the Header. Please Rate My Response! Thanks!4ZYEV3
SOURCE: WHAT IS THE DIFFERENS OF CHRYSLER GRAND VOYAGER
THERE ARE A COUPLE DIFFERENCES. IT'S ALL IN THE OPTIONS PACKAGE. GRANDS ARE JUST SLIGHTLY LONGER, THEY HAVE DIFFERENT MOTOR SIZES AND DIFFERENT OPTIONS PACKAGE.
SOURCE: changing fuel pump on chrysler 2000 grand voyager
you have to drop the gas tank out from under the vehicle. You must first drain as much gas out of the tank as you can. Then support the tank with a jack. Preferably with a large plate. Then remove the retaining straps. If you can remove any of the fuel lines and fill nozzle before lowering please do. If you cannot, lower the tank until access to wiring harness and fuel line disconnects can be made. With a special fuel line tool remove lines and harness and anything else that may hinder the removal on the tank. Once the tank is out from under the vehicle remove as much dust and debris as you can fom the top of the unit. Remove the retaining ring using a hammer and a punch, or screwdriver. Once the retaining ring has been removed carefully remove the fuel pump assembly from the tank. be careful not to damage the float. replace pump in the reverse order above.
SOURCE: fit a water pump on a grand voyager
Dear Waterpump Fitter,
These voyagers are actually fairly easy to install the waterpumps on, The pump is located on the passenger side of the vehicle closer to the front (towards the bumper) It should take the first or second timer maybe a couple of hours to install.Please et back to me if you have any other questions..I'M HERE TO HELP!!
145 views
Usually answered in minutes!
×