Question about 2003 Jeep Grand Cherokee
All WJ models have two fuel filters, a strainer filter at the bottom of the fuel pump module inside the fuel tank and one exterior filter within the fuel pressure regulator. Both filters are designed for extended service. They do not require normal scheduled maintenance. Filters should only be replaced if a diagnostic procedure indicates to do so.
The combination fuel filter/pressure regulator is located in front of the fuel tank and above the rear axle. It is transversely mounted to a chassis crossmember (left-to-right). The filter/regulator is equipped with 3 fuel line fittings (2 at one end and 1 at the other end). The single fitting facing the left side of the vehicle is the supply line to the fuel rail. The 2 fittings facing the right side of the vehicle are connected to the fuel tank. Of these 2 fittings, the fitting towards the front is used for fuel return to the fuel tank. The fitting towards the rear is a pressure line.
Fig.: Fuel filter / regulator location
External filter/regulator removal
WARNING: THE FUEL SYSTEM IS UNDER A CONSTANT PRESSURE (EVEN WITH THE ENGINE OFF). BEFORE SERVICING ANY FUEL SYSTEM HOSES, FITTINGS OR LINES, THE FUEL SYSTEM PRESSURE MUST BE RELEASED.
1. Remove fuel fill cap.
2. Remove fuel pump relay from Power Distribution Center (PDC). For location of relay, refer to label on underside of PDC cover.
3. Start and run engine until it stalls.
4. Attempt restarting engine until it will no longer run.
5. Turn ignition key to OFF position.
6. Disconnect negative battery cable at battery.
7. Raise vehicle.
8. Clean area around 3 filter/regulator fittings.
9. Disconnect fuel supply, fuel return and fuel pressure lines at filter/regulator. Special tools may be required.
10. Remove 2 mounting bolts and remove filter/regulator.
External filter/regulator installation
1. Before installing filter/regulator, be sure all fittings are cleaned of all dirt and contaminants.
2. Be sure o-ring is positioned into fuel return fitting in filter/regulator.
3. Apply a small amount of clean engine oil to o-rings.
4. Position filter/regulator to body and install 2 bolts. Tighten bolts. Refer to Torque Specifications.
5. Connect 3 fittings.
6. Connect negative battery cable to battery.
7. Start engine and check for leaks.
Hope helps (remember rated this).
Posted on Jul 05, 2010
Tips for a great answer:
Dec 04, 2016 | Cars & Trucks
Apr 07, 2016 | Cars & Trucks
Jan 25, 2016 | Cars & Trucks
Jan 05, 2016 | Kia Cars & Trucks
Nov 21, 2011 | Chevrolet Lumina Cars & Trucks
Apr 13, 2011 | 2008 Ford Edge
Jun 13, 2010 | 2002 Kia Sedona
May 15, 2010 | 2003 Suzuki Grand Vitara
Jan 06, 2010 | 2005 Peugeot 405
Jul 01, 2009 | 1990 Ford F350
2,032 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: