Position the seat as you know it fits best - putting each bottom leg over the hole in the floor. Lean the seat forward like you wanted to just get to the back of it - like if you leaned a kitchen chair forward. Now be sure the bottom portion of the seat is down in the hole a little - one on each side and then simply lean the seat back to an upright position. If it doesn't slip in and click - try spraying WD 40 or better yet - get a can of white lithium grease and spray that into the holes. LOOK CLOSE and STUDY the bottom of the SEAT and the little holders in the FLOOR - it will come to you they simply sit and lock onto each other. To remove the seat -- at the bottom of the seat is a handle pull - some have one on each side. pull this.
You can do this I can assure you.
Thanks
Gary @ Fix Ya
SOURCE: How to put on Serpentine belt for 92 Chrysler Lebaron 3.o liter engine
Before replacing or installing the old belt you need to check all of the pulley's that the belt rides on for play. Pay special attention to the spring loaded tensioner pulley. They can sieze and cause the belt to come off.
I found this picture it is a bit large for the screen.
294 views
Usually answered in minutes!
×