Question about 2002 Land Rover Freelander

2 Answers

Freelander 1.8.window down cable snapped.Up cable twisted.possible solution please

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Land Rover Master
  • 22,485 Answers

Complete new unit only solution

Posted on Aug 18, 2010

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Director Badge:

    Uploaded 100 video answers.

  • Land Rover Master
  • 110 Answers

Posted on Mar 10, 2019

Ad

1 Suggested Answer

Anonymous

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi, freelander 2 td4 2007 driver door window comes down on its own at random whilst vehicle is locked. Please help. Thanks..


Hi,some times after battery is discannected this can happen.
I would try closeing the window up,then hold the switch so as if to close the window and hold for 5 seconds,then try opening up and dow a few times,then try locking freelander up and see if that helps cure it.
I hope this works for you,it did for me a few years ago.

Dec 08, 2014 | 2007 Land Rover Freelander

1 Answer

To open bonnet on a 04 freelander cable snapped


Depending upon the design of the vehicle, sometimes it is possible to open a latch from underneath using a straightened coathanger and lots of patience. Someone has to press down on the bonnet to relieve spring tension on the latch while work underneath proceeds

Aug 22, 2013 | Cars & Trucks

1 Answer

How do you remove door panel off a freelander 51 plate. Winder making a grinding sound and sticking at times all help welcome


Yes they're easy to fit but there is a point to watch to avoid instant failure of the cable.

proceed as follows (5 door).......

remove the screw from behind the interior door handle and remove the trim
carefully prise the door pull trim off and remove the screws from behind
05 models onwards, remove the window switch assembly by pulling the whole black trim upwards
remove the plug behind the springy cup holder thing and remove the screw inside
finally remove 4 screws from the lower part of the door trim
carefully prise the door trim from the door and try to avoid breaking any clips

To get the reg out.......

Carefully remove the water shedder, this is easier said than done and really it should be relaced, if you have a new one, just rip it off.

Now, the point to watch, before removal, look at how the cables cross over and the cable nearest the outer side of the door crosses over the inner one and is clipped to the inner door skin, it MUST be refitted this way to keep the cables away from the window otherwise the window will catch the cables when wound down and break them, this is a common mistake so take your time and look before removing.

Next, Wind the window down (if you can) and loosen the 2 bolts that hold the window to the regulator, pull the window up and tape it to stop it dropping. If you cant wind the window down, cut the cables.

Remove all the 10mm bolts that hold the reg in and wiggle the reg out of the door.

Twist the new reg so the cables cross as previously mentioned, make sure they cross the right way, the cable with the pad should be nearest the inner door skin with the one without the pad crossing it on the outside.
Fit the reg in the door and tighten all the bolts, clip the non padded cable to the clip on the inner door skin.
refit the window.
Now, check the operation and make double sure the window doesn't catch on the cables, once your happy, fit the shedder and the door trim.

Jul 20, 2010 | 2002 Land Rover Freelander

1 Answer

Remote control for land rover freelander not working at distances


Replace the battery in the key unit. There is a slot on the bottom edge for a coin or screwdriver to twist it open. Open, replace battery and snap shut.

Please rate this answer. Thank you.

Mar 28, 2010 | 2002 Land Rover Freelander

3 Answers

2000 Freelander-window stuck in down after cable replace


Firstly check the wiring then motor is only working one way that means that the power is not being reversed to put it back up, switch the wires around from the switch if it go's back up then you know there is a wiring fault.

hope this helps
Regards
Dan

Feb 04, 2010 | 2003 Land Rover Freelander

1 Answer

A 2004 Ford Expedition Eddie Bauer driver side window not working


The entire assy. This uses a cable system and what you are hearing is the cable twisting and getting ready to snap. New units are available at Advance Auto parts

Jan 14, 2010 | 2004 Ford Expedition

1 Answer

Hi, please help!! The cabels on the Freelanders back door window are not connected. Where can I get info on how to connect it. Thanks Hennie


Unfortunatly a Freelander rear doorglass has a cable/pully regulator system. if the the cable has become disconnected it usally means something has broken and the regulator has to be replaced.

Hope this helps

Jan 06, 2010 | 1999 Land Rover Discovery

1 Answer

When i press my central locking fob only 1 door opens


sequence for freelander lock unlock, to lock 1press = door lock , 2press = door dead lock , to unlock 1 press = driver door unlock, 2 press = passenger doors unlock, also rear window can be operated from fob to do so press and hold unlock button for 3 or more seconds and rear window will roll down.neat feature.hope this helps

Sep 02, 2009 | 2003 Land Rover Freelander

3 Answers

How do you connect the power windows?


They are supposed to be connected to the motor. Does the motor run when that doors individual switch is pressed? What do the ends of wire look like, connected to something or does it have clips at ends? If motor still runs then these wires are for manipulating the rack& pulley system for operation of the window glass.........sodeep

Aug 03, 2009 | 1994 Toyota Camry

1 Answer

Freelander tilting seat


covers come off easy when your not scared of it and make your own cable with a bicycle cable

Jan 22, 2009 | 2003 Land Rover Freelander

Not finding what you are looking for?
2002 Land Rover Freelander Logo

Related Topics:

269 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85223 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...