My car keys are stuck in the ignition system. (1994 Saturn). Can't turn it in or pull it out. Any ideas?

Your ignition could be stuck. That happened to me on my 2002 Chevy Malibu with 150,000 miles on it. The ignition sometimes gets stuck and freezes up. You'll have to pull it out and put a new one in. You can use the new key or have it re keyed to fit your old keys.

under the ignition there is a little tiny hole put the ignition to the on position and stick a paper clip in that tiny hole and you can then pull out the ignition switch. this happened to my daughters car and I did this procedure but somebody playedwith it before my so I had to get a lock smith to get it out and he hadknow idea what he was doing. we got it out but the PCU lost memory and the car wouldnt start. The dealer wanated a lot of money to fix it so I took it to my mehanic and he rerouted it by using a diode and its been running like a charm for 4 years. there are also many vedeos on youtube and other saturn sites that can help

u need to replace the ignition lock cylinder

Is the key stuck because you have an automatic transmission and you are unable to shift it into P (park)?

lock cylinder come apart on inside(tumblers) you will need to replace lock cylinder code the ignition lock cylinder and get a new key

It needs a new lock assembly. Or you can do as all the car thieves do and buy a slide hammer and pull your lock out and start it with a screwdriver

Put some pressure on the steering wheel in one direction or the other this may take the pressure off the cylinder itself and allow you to do what is needed...hope this works.

i had the same problem on my 99 malibu.i called a locksmith and he came out and tapped the key with a small hammer.he said that sometimes the wafers will get stuck in the up position if the wrong key or a new key is inserted into the ignition.after a few sharp raps the ignition turned,but since i had him there i had it replaced.he said lubricating it would work.

ignition switch broke or the car is dieseling the idle speed is too high throttle valve stuck open or the valves and heads full of carbon build up.causing preignition.

had the same problem. try to get some graphite powder with the small applicator tube and squirt some in your ignition assembly. sometimes this loosens it up