Firing order for 1995 isuze rodeo - 1995 Isuzu Rodeo

Isuzu Rodeo fuel cut off inertia switch Questions & Answers ...

www.fixya.com > ... > fuel cut off inertia switch > Cars & Trucks > Isuz
Isuzu Rodeo cars & trucks fuel cut off inertia switch questions and answers. Ask your Isuzu fuel cut off ... cut off inertia switch. Ad. Question about 1995 Rodeo.

Isuzu rodeo fuel cut off switch location - Fixya

Hello Harvey, My information shows firing order of 123456. #1 being passenger's front cylinder and #2 being driver's front cylinder.

Do you not own any tools or never
worked on any motor vehicle?

Metric wrenches & sockets

Check the fuel pressure, the test port is under the hood on the top of the engine, press the valve fuel should spray out while cranking the engine,.

It is inside the transmission under the belly pan mounted to the valve body. You just remove the transmission pan (not the transmission for heavens sake) and replace the shift solenoid pack.

if it is a 3.2 v6 it is internal you have to remove the timing belt cover on the front of the engine the water pump is driven by the timing belt it would be wise to replace timing belt at the same time

Hi!!
This is the info. you requested:


A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa.

FIRING ORDER FOR 2.6L ENGINE 1 3 4 2 FIRING ORDER FOR 3.2L ENGINE 1 2 3 4 5 6

1995 Isuzu Rodeo (2WD)
3.2 liter SOHC V-6 (6VD1)

123456 IS THE FIRING ORDER... RIGHT BANK (RIGHT AS IN SITTING IN THE DRIVERS SEAT NOT STANDING IN FRONT OF THE CAR)STARTING AT FRONT IS CYLINDER 1 THEN 3 THEN 5 THEN THE LEFT BANK IS CYLINDER 2,4,6, FRONT TO REAR... THE COILS FROM LEFT TO RIGHT (STANDING IN FRONT OF CAR) ARE 1,4,6,3,2,5 HOPE THIS HELPS