SOURCE: 2007 honda ridgeline vibration in the steering wheel
I used to work for honda and found this issue only once. After checking the driveshaft, differential, and tires, i found that the drive axles were the problem with vibration in the steering or upon acceleration.
SOURCE: warning lights srewdriver,vtm-4 and engine light are on
Bring it to a dealer immediately. VTM-4 means the 4WD is off, possibly because of the engine line or vice versa.
SOURCE: Replace the tail light in a 2006 honda ridgeline
Open the tail gate, and remove the 2 screws on the side.
SOURCE: how to change a serpentine belt on 2007 Honda
You'll need a 1/2 inch socket wrench to fit on the inlet of the idler pulley. You'll also need an extension bar to lengthen the socket wrench because the wrench alone won't be long enough to reach. Apply pressure to the pulley to take the tension off the belt. Slide the belt off and then install the new one using the diagram under the hood as a guide. Check this thread for some photos:
http://www.ridgelineownersclub.com/forums/showthread.php?t=28138
SOURCE: I have a 2007 honda ridgeline. When my head
It could be the wrong bulb in the brake lights/ TS
Whenever
this warning light or any other stays on in the dash it is indicating
that the systems control module (or the system sensor in the case of
lights like low oil pressure, door open indicators etc.) has detected
a fault, it then disables the system (this applies to ABS,TCS, TCM,
SRS and BCM faults and others) as long as the light is on. You must
now have the dealer hook up a special electronic diagnostic tool and
"scan" the system for the fault code that is stored for the
problem(s)
Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module
859 views
Usually answered in minutes!
×