SOURCE: serpentine belt diagram for a 5.9 diesel with air and 9 pulleys
5.9L DIESEL
The 5.9L diesel engine accessory drive system (with a/c) consists of :
CAUTION:
When installing the accessory drive belt, the belt must be routed correctly. If not, engine may overheat due to water pump rotating in wrong direction. Refer to or for correct engine belt routing. The correct belt with correct length must be used.
1.
Position drive belt over all pulleys except water pump pulley.
2.
Attach a 1/2 inch ratchet to tensioner.
The 5.9L diesel engine accessory drive system (without a/c) consists of :
3.
Rotate ratchet and belt tensioner clockwise. Place belt over water pump pulley. Let tensioner rotate back into place. Remove ratchet. Be sure belt is properly seated on all pulleys.
SOURCE: Need serpentine belt diagram for Dodge Ram 3500 diesel truck
no you should be able to do it There should be a routing label on the underside of hood or on the radiator support/ Its should not be very hard if you have one already just loosen the Alternator it will slide down get the other one ready look to see the way its routed then slide the new one and tighten up the alternator thats it/ Please rate my response thank you very much
SOURCE: 2006 Dodge diesel belt routing diagram
Here's a link to the diagram you need...
http://www.gates.com/common/part_locator/view_diagram.cfm?id=S8023
Testimonial: "Awesome! thank you so much for the quick response!"
SOURCE: Need serpentine belt routing diagram for 1994 Dodge grand caravan
3.3L?
Looking at the engine from front (right side of the Van): Stating at the Top, Going Left to Right and Clockwise:
Over the Alternator
To under the Idle Pulley,
To Over the AC Compressor.
To the Left Side of the Water Pump.
To the Right side and Under the Crankshaft Pulley
To the Right side and Over and Down the Tensioner
To Under the Power Steering Pump
And Back up-to the Left side of the Alternator.
Advise when puting it on:
Put the Belt around everything else accept for the Alternator. After it is around all the rest of the Pulleys - Pull the belt up - tight from the Power steering Pump and the Idle Pulley to form a loop, holding the Belt close to the Altenator Pulley.
Using the 15mm wrench or belt tensioner bar - rotate the Tensioner Pulley towards the front of the Van and then place the belt over the Alternator.
Let me know if this helped or if you have additional information or questions. Feel free to contact me at FixYa.com!
Fig. Accessory serpentine belt routing-6.5L Diesel engines
Fig. Accessory serpentine belt routing-6.6L Diesel engines
Hope this helps (remember to rate this answer).
508 views
Usually answered in minutes!
×