SOURCE: volvo 850 turbo wagon motor mount failed inspection
if this is the right front mount just behind the r/f wheel that would be ok, if this is the top mount on the engine below the windsheild go to IPD Volvo site and get the mount and do it yourself (easy)
SOURCE: 95 volvo 940 DL hesitates injector error codes 113, 212, 232
Check the fuse to the injector. If it is out or got wet, it could mimic these conditions. let me know what happens. I have an 85 model.
SOURCE: I have a 88 volvo 740 GLE and it wont fire.
The problem wont be your timing belt. you need to take out a spark plug plug it into your HT lead and check for a strong spark or even if there is a spark. check your contact breakers on the distributor as well
SOURCE: car is stalling and idleing irradically.
I Would Suggest That You Complete A Engine Cylinder Leak Down Test.....(not A Compression Test But A Leak Down Test) this will tell you if you have internal problems....possible worn rings or a burnt valve(s) I would use a smoke machine to check for vacuum leaks also. Good Luck
SOURCE: 1991 volvo turns over but wont start
If your air mass meter tests good, the I would tell you to check the HIGH PRESSURE PUMP underneath the Driver's side chassis pump holder-next to the fuel filter.
There are 2 pumps on your Volvo---the in-tank low pressure, and the chassis mounted high pressure. The car will run with the in-tank failed and the high pressure good. It will not run with the high pressure failed. Test the pump by applying voltage to the two terminals.
Another common failure, should the high pressure pump be good, is the HALL EFFECT SENSOR located in the distributor on the back of the engine. Once this sensor goes, it's no start. A rebuilt or used distributor may be the answer to your problem.
187 views
Usually answered in minutes!
×