Here are procedures for removing the ignitionlock assy. If equipped
with SRS, extra care must be taken while removing ang installing to
avoid damage to the SRS cable reel.
IGNITION SWITCH & LOCK CYLINDER
Removal
1. Remove steering wheel and combination switch (if necessary).
Disconnect ignition switch harness connectors. If shear bolt studs are
accessible, use a hacksaw to cut slots into exposed studs.
2. Remove studs using a screwdriver. If shear bolt studs are recessed
or hard to reach with hacksaw, use a center punch on studs. Using a
drill bit and screw extractor, remove studs. Place key in ACC position
and remove ignition switch and lock cylinder.
Installation
To install, reverse removal procedure. Install NEW shear bolts. Tighten
shear bolts finger tight. Ensure proper operation of ignition switch
and lock cylinder. Tighten shear bolts until heads break off. Install
combination switch, upper and lower steering column covers and steering
wheel (if removed). Tighten steering wheel nut and Torx screws to
specification.
561 views
Usually answered in minutes!
×