SOURCE: P105
it is located on the intake manifold,tocheck turn key on,probe volt.on1st and4th wire of sensor plug normal reading is4 to 5volts if ok,start car let run till norm. temp.probe wires again while car is idling,norm.reading is0.4 to 2volts,if any of these is out of range change sensor
SOURCE: o2 sensor bank1 sensor 1
usually bank 1 sensor one is closest to the motor(guess) but you can look it up in a manual and just changing the 02 sensor is gonna fix it they are anywhere from 40 to 100 dollars hope it helps
SOURCE: What is the fix to a P0108 Manifold Absolute
It sounds like you (MAP) sensor needs replacing
SOURCE: manifold absolute pressure/barometric pressure
CHECK MAP SENSOR VACUUM HOSE FOR CRACKS AND LOOSENESS.CHECK ALSO MAKE SURE ELECTRICAL CONNECTOR NOT DAMAGE.IF ALL IS GOOD.REPLACE MAP SENSOR.
SOURCE: P0705 Transmission range sensor circuit
The sensor should be located where the shifter cable is attached to the trans. It will have a plug with several wires. Usually there will be a way to align it, like a hole with a pin when it should be in neutral.
Symptoms of a P0105 check engine light code
may include:
113 views
Usually answered in minutes!
×