SOURCE: 1998 Grand Prix 3.8 supercharged fuel pump wont
It should be located on the outside of the frame rail,forward of the right front tire. It should look like a ceramic type ballist with a pigtail and one bolt holding it on. If the pigtail has a connector dont forget to check for water, rust, etc. also check for wire damage. It should be the culprit though since by jumping the relay you are in theroy bypassing the resistor. I hope this is correct I didnt have time to pull a diagram and look at it but I am pretty sure this is correct. Thank you for your vote and comment. I hope this helps, good luck my friend.
SOURCE: 1998 pontiac grand prix starter
disconnect the negative battery terminal first then disconnect the positive treminal so there are no accidents, raise the car safely go underneath & remove the starter cover should be 3 10mm bolts holding the cover on then remove the 2 through starter bolts 15mm then disconnect the + battery cvable from starter then disconnect the solenoid wire should be a 7 mm bolt. good luck
SOURCE: 1998 Pontiac Grand Prix GTP Supercharger coupler
The rattle you are/were hearing is typical on the Eaton blowers. After they get some miles on them, the coupler wears out and the holes become ob-longed or out of round which causes the rattle you are hearing.
Usually at idle you can hear it very clearly.
I have changed a few, and they are pretty simple to change. Just take off the supercharger belt, then you may have to remove your alternator bracket, depends on which years, drain the supercharger oil with a spray bottle sprayer (it does stink badly) then just remove the 10 or so bolts that hold the snout to the housing. Remember to keep track of where they go, some are different lengths.
You may have to use a rubber mallet, or your hand to hit the snout around to break the gaskets loose. Pull off the old black hockey puck looking thing (coupler) clean out the snout, attach new coupler, then reassemble and put new supercharger oil back in, and your rattle will be gone, at least for another 100k miles.
Best place to get a coupler is at,
http://www.zzperformance.com/grand_prix/products1.php?id=155&catid=106
Costs about 30, plus the few bottles of oil for the supercharger.
SOURCE: replace thermostat on 2003 grand prix gtp with
The thermostat housing is located in the upper radiator hose. You will see a metal elbow secured by two bolts into what I remember is the upper intake manifold...don't quote me on that but you will see it regardless of whatever I call it. Anyways, GM decided it was a good idea to put stainless steel bolts in there but that makes it easy to strip the threads in the bolt hole so I think it's best when you put your wrench on the bolt to just tap on the handle till you vibrate it loose, then turn it.
When you pull off the housing you'll lose a little coolant and it will create an air pocket which we'll address. It's a 50/50 chance that the thermostat housing gasket will either stick to the housing or the engine...it may be torn, cracked or flaking in either case clean both contact surfaces before you replace the gasket. I recommend an oil impregnated poly material gasket.
Note the position of the thermostat in the hole and place the new one in as such.
I recommend a 180 degree thermostat...stock is 195 but the GTP runs better with the 180.
Put on gasket and reinstall the hose/housing assembly, alternate from one bolt to the other so the housing mates flat and cannot cause a leak.
Next, fill the coolant overflow bottle to the "HOT" mark. If the bottle is dirty and hard to see just put a light on top of the bottle...GM didn't mark it very well so if it's not squeaky clean you can hardly see a damn thing.
*IMPORTANT** if your car still has Dexcool in it, DUMP IT. It will eventually destroy the motor.
If not...continue on. Start the car. Go back to the thermostat housing and place a rag on top of, and twist the peacock valve on top of it to let the air out until it starts to get coolant on the rag. Done.
SOURCE: grand prix torque converter locks up too soon
Either the speed sensor, TCC solenoid , ECU or a stuck check ball in a lockup plate. I recommend taking this to a transmission shop this could get fustrating.
Testimonial: "thankyou"
106 views
Usually answered in minutes!
×