SOURCE: How to changing the headlight
Take screws off the front cover about 10-20 screws Reemove cover then two screws by the headlight Pull wole healight out, Repalce bulb. Not that hard. Read the manuel. My 16 year old did it with her Dad
SOURCE: oil pan removal on 2002 gmc sierra
did you pull the rubber plugs between the motor and trans out? there are either nuts or bolts up there
SOURCE: Removal of oil pan?
The car has three mounts in a triangle configuration. The front trans mount, the passenger side motor mount and the rear motor mount. I do not know if anyone has ever successfully raised the engine to slide the pan out, but remember, if you do this, the pan goes back on with anaerobic gasket maker on it, so make sure you can slide it out with grating on the underside of the block. If you can't, then it will likely be impossible to get back in place without smearing the gasket maker all over and making a heck of a mess. The commonly accepted way to remove the pan is to remove the two front subframe bolts and allow the subframe to drop enough to get the clearance you require. The bolts are 18 mm heads and are really torqued on there so you will need a serious breaker bar and cheater bar to go with it. USE SOLID JACKSTANDS or BETTER YET, RAMPS to do this. The force you will need to apply can take the car right off a single jack.
SOURCE: I have transmission leak, i mean it comes right
maybe the seal between the pan and tranny. or maybe the drain plug on the tranny has came loose.
SOURCE: i am replacing the oil pump on a 98 chevy malibu,
take loose the motor mount bolt and jack the front of the engine up to clear the oil pump and remove the pan,.the bolt the runs thru the center of the mounts ,the easiest way ,hope this helps you, thanks robert b.
424 views
Usually answered in minutes!
×