Remove negative battery cable. Remove heat shield from starter. Remove battery cable from starter lug and single wire connector to starter solenoid. Remove starter. Above starter is CRANKSHAFT POSITION SENSOR. Disconnect sensor connector right below ignition coil assemble from top of engine. Slide sensor connector out of U-shaped bracket. Loosen 10mm bolt securing sensor. Lubricate new sensor O-ring with vaseline and install. Reverse procedure to finish job. I just did the job on my 03 Tibby 2.7liter today. Note: Make sure you press the new sensor in by hand and be sure it is seated all the way before you tighten the 10mm bolt, otherwise the sensor mounting tab make distort and crack and the sensor may not be in all the way. Good luck!
640 views
Usually answered in minutes!
×