Low beam headlights work and the high beam light lights on the dash
Hi,
To my knowledge a 2003 Toyota Camry uses a dual filament halogen bulb, either by Osram, Philips or Sylavania. If on the dashboard, the blue indicator lits when the switch is moved to bright or the passlight is engaged but no headlight, then it could jut be busted bulb (or part of it since you still have driving/low beam). In some cases, it could be the relay that supplies power direct to the bulb. At other times, it could be fuse(s) assigned to high beam. At certain instances, it could be also a loose, corroded or burned connector.
Corrective measure for your concern would be to check the 2 bulbs. This is performed by removing the rear covering (rubber or plastic cap) of the headlight assembly from the rear. The bulbs are held in place by a spring clip that needs to be unlatched from the base/holder. Carefully remove the bulb taking care not to touch the glass envelope. The filaments would be readily visible and cut/breaks would be apparent. If determined that one of the filaments (high beam) is open, replace the bulb(s).
If the bulbs prove to be OK, you need to work yourself backwards tracing the wiring harness. After the bulb, check the 3 prong connector for any corrosion or scorching/burnt marks; clean as maybe required. Next to check would be the relay that provides the +12VDC and then the fuse.
I doubt if the dashboard or steering wheel components involve with headlights may be at fault.
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.
Good luck and kind regards.
Thank you for using FixYa.
593 views
Usually answered in minutes!
I found 1 high beam bulb was burned out,so i replaced it and the other high beam did not work so i replaced that one also.
the high beam and driving lights now are working.
thank you.
No Low beam or ddl on 1999 toyota Seinna
high beams are the only thing working....
high beams
high beams don't work. high beam indicator works. could the relay be bad?
Both low and high beam headlights work. Indicator light on dash does not 'light up' when high beam headlights are on.
only high beam lights work
both were working, then just the right, then both, now neither
My optima2009 high beam lights don't turn not workin
Pontiac G6 low beam headlights don't work, high beam headlights do work. 2008
head lights don't work but high beam works
×