P1400 code
Gadiame: The code P1400 is for the EGR valve and Evap canister purge control solenoid valve circuit.
An improper voltage signal is being sent to the ECM through the solenoid valve.
As far as whether the engine using a timing belt or gear? You mean chain? This engine uses a timing chain.
If I can answer any other questions, write me.
SOURCE: code p1400 on my nissan
P1400 - EGRC Solenoid Valve
The P1400 code is for the EGR solenoid and not for the valve. The
solenoid control the opening and closing of the valve. You should check
the solenoid hoses and the connector. Also check if there is voltage at
the green/yellow wire.
Hope helps.
SOURCE: nissan altima 95
That code is not in my book, it is a dealer specific code. Go to Auto Zone or Advanced Auto, and they will have a book that has "dealer" codes in it.
2,524 views
Usually answered in minutes!
Check engine light is on in my nissan 1997 Altima GXE/GLE Model.
is this model uses timing belt or gear?
I had a knock sensor code and an egr valve code come up. I put in a new knock sensor and egr valve only to have a egr solenoid (P1400) code come up. Checked all vacuum hoses and put a meter on the wire side of the solenoid. Vaccum hoses all pull vacuum on gauge and 12.43 volts on circuit. I figure solenoid is sticky or has some debris in it from old valve. Should I replace this too? I really am trying to avoid replacing my engine one piece at a time! Any insight would be greatly aprreciated.
×