Here's a link to where your Crankshaft position sensor is. GET 25 GIFT CARD FOR EVERY 100 SPENT ON ONLINE SHIP TO HOME ORDERS ,yes,the camshaft sensor is in the distributor.Also check this video out. 2000 Nissan frontier 3 3L V6 no crank no start possible lo
SOURCE: sensor locations
Here's the diagnostic procedure for DTC code 0340, directly from the service manual:
SOURCE: truck burns alot of fuel, hesitates all the time
If you have that code the distributor isn't set right. I don't suppose you have access to a scanner? That is the only way to get it set right.
SOURCE: 2000 Nissan Sentra Crankshaft Position and Replacement
Go to dealership they will give a diagram to locate every single one. I replace them on my daughter car. I believe there were three sensors. I exactly know what you are talking about. I had a hard time locating the back one right above the drive shaft on driver side.
SOURCE: crankshaft and camshaft sensors location in nissan altima 2003
You are incorrect sir. There is a very good Youtube video showing you exactly where it is that is how I changed mine. The Crankshaft is located behind the engine block below and around from the cam sensor which is easly spotted looking at the engine. The crankshaft is in a difficult spot but once you figure out where it is it's easy...ish hope this helps
SOURCE: 2000 nissan frontier knock sensor code & distributor
no but the knock sensor does send a signal the ecm and it will ****** or advance the distributor timing
1,880 views
Usually answered in minutes!
×