Brake warning lining wear

adjust the tension or check spring return

Brake warning light could mead a damaged ABS senser, perhaps happened when the brake line was replaced

It's an yellow warning indicator lamp. It lights when brake pads are weared. Now it's time to replace weared brake pads!




Please do rate my response. Thanks!

I can't show you a picture of brake lining wear but I can explain what it is. Brake lining wear is your brake pad wear. If the instrument cluster is showing "brake lining wear' ' visit workshop' it means your brake pads have worn down and are now at the brake pad wear sensor.

It's an yellow warning indicator lamp. It lights when brake pads are weared. Now it's time to replace used brake pads!

hi from uk the stop/handbrake light has two warning functions it will illuminate when hand brake is applied or is left on whilst driving or not fully off position ?? the other function is it is warning you that your brake fluid in the reservoir is low/requires topping up ? if it is low ? this could be due to a fluid leak ?either from pipes or wheel cyl's/calipers ? OR ? just that as your b/pads and shoes wear lower then fluid from reservoir displaces from res to cyl's to compensate for wear so may i suggest you 1st check fluid level+top up if low? then check for leaks as above more important have your brake pads and rear shoes or pads if fitted checked for wear/safety i advise this considering age/milage? of car and if you have no record of being checked/replaced recently? if your brake pads are fitted with low pads wear indicators this will also give warning hope this helps? good luck !

you need to have new pads and rotors installed,the rotors is where your vibration is coming from

This warnign light means BRAKE WEAR (visit workshop)
Cause:
(Warning) The brake pads / lining have reached their wear limit.

Possible Solution:
Have the brake pasd - linings replaced as soon as possible at an autorized Sprinter Dealer.

I hope helped with this. Good luck.

Hi I am vortash .. check that the sensor lead is not damaged at the brake calliper and check that the brake pads havent worn down again ?,, If they have I would suspect that you have a stiff calipper cylinder that keeps pressure on the pads against the Disc or drum and it needs freeing off and smearing of copperite grease you may check this by driving a few miles then feel the back wheels if they are warm then the pads are rubbing ..( be careful that can get hot enough to take your skin off if you touch them , you should be able to smell the linings also if it is this problem .. hope this helps regards Vortash

check your brake fluid level( as this light is the hand brake warning light) but if it comes on with the hand brake in off position and ignition on it warning low fluid level in the braking system