REMOVE THE CAP FROM THE RESIVOR AND YOU WILL SEE A STICK GAUGE AS PART OF THE CAP, WIPE CLEAN AND LOOK AT THE GAUGING ON THE STICK TO SEE WHERE THE FULL MARK IS, ALSO MAKE SURE ENGINE IS WARM, PUT CAP ON AND THEN REMOVE AND SEE WHERE THE OIL GOES ON THE STICK IF LOW ADD AS NEEDED AND CHECK AGAIN, THEN START ENGINE AND TURN WHEEL TO LEFT AND FULL RIGHT TURNS AND THEN BACK TO STRAIGHT, SHUT MOTOR DOWN AND CHECK THE LEVEL AGAIN IS STILL LOW ADD AGAIN, HOPE THIS HELPS.
Testimonial: "Thank you that was helpful, but where is the resivor located at? "
SOURCE: Where to add power steering fluid?
if u have the owners manual in the vehicle i would refer to that r call your local dealer
SOURCE: my vw needs steering fluid, where does it go?
Go to Autozone
If your a girl they will show you or maybe even put it in for you, try picking a day or time when there not busy like during the week in the morning when they open
SOURCE: Steering wheel is hard to turn
your rack and pinion may be going bad. Does it stick at times?
611 views
Usually answered in minutes!
×