My 1993 corvette wont start - 1993 Chevrolet Corvette

sounds like you need a new distributor.... if you had a new water pump put in lately and didnt change the distributor that would be your main problem. The water pump in located in front of distributor, if that leaks it will short out and fry the distributor. Always change distributor when water pump goes.

check your fuel pressure should be 35 to 42 with key on engine off,and about 5 to 7 more with engine running and vacuum line off the regulator,also check your fuel regulator with vacuum off it should be dry if it is wet with gas it is bad

Bad distributor..... causes could be if you had water pump problems before and water leaked behind pump onto distributor it will fry..always replace distributor when water pump goes

you need new headlight

fuel filter-replace or stuff in gas tank clogging up

i would look at your battery first then the starter relay the question is a little vague what car is it do you have a good battery and conections check the fuses and relays

Assuming you have replaced the fuel filter, you would check the pressure at the fuel rail with a gauge.

The cooling fan relays are located on the upper radiator support in front of the left front wheelhouse.

you have 2 relays for your fan, primary and secondary
their controled by the PCM according to the temperature

replace blower control module

engine will turn over,but wont start.just re placed gear and timing chan. set timing marks up,top one at 6oclock bottom at 12o clock