2008 dodge Magnum esp light is on hit button to turn off won't turn off? Help.....

Check fuse.

Pop the hood then go too front of car and hit hood near front with your palm. Try two or three different locations

Fuse panel is located beside the battery in the cargo hold.

There should be a button labeled ESP next to the hazard switch.

(Page 343 of your owners manual)
This mode is entered by momentarily depressing the ESP
OFF switch (located in the center switch bank, next to the
hazard flasher switch).
When in Partial OFF mode, the TCS portion of
ESP, except for the "limited slip" feature described
in the TCS section, has been disabled
and the ESP/TCS Indicator Light will be illuminated.
All other stability features of the ESP function
normally. This mode is intended to be used if the vehicle
is in deep snow, sand or gravel conditions and more
wheel spin than ESP would normally allow is required to
gain traction. To turn ESP on again, momentarily depress
the ESP OFF switch. This will restore the normal ESP ON
mode of operation.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Retrieve the codes, as you have on any vehicle in the last 30 years,
& diagnose from the code

On this websites you find fuse box description for Dodge Magnum (2008)

https://www.carknowledge.info/dodge-magnum-srt-2008-fuse-box-diagram/
https://www.autogenius.info/dodge-magnum-srt-2008-fuse-box-diagram/

the esp stands for electronic stability program,you will need to have the computer scanned for codes, these codes will help in the repair,you may have a bad speed sensor or the check engine light may have shut down the esp,when the engine detects a problem it shuts down the esp because it feels that the esp cant operate correctly when the engine is not running correctly,so the first thing is to scan for the codes, hope this helps, good luck,

C1041 code is-Left Front Tone Wheel Performance
the speed sensor was slower then the other front one to react to something,or the left wheel spun and not the right front one,
or there is a problem in the sensor or wiring

MAYBE NEED TO RESEST THE COMPUTER

you need to see what the eng lite for if there is a trans codes usually the pcm wont let the speed go over 40 stays in safe mode untill you fix the problem or change the sensor,for the esp you need to chage the esp sensor and recalibrate by the dealer