Question about 2005 Chevrolet Blazer

1 Answer

Want to drain rad & engine - 2005 Chevrolet Blazer

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 318 Answers

There should be a drain **** on the lower part of your radiator. Sometimes it is under the lower rad hoes. If not - remove the lower rad hose . Be sure the engine temp is down - do not burn yourself. Also be sure and collect the coolant for disposal. Anti freeze can harm not only the environment but animals can ingest it and be harmed or killed. It is a good idea to remove he rad cap to allow air into the top of the rad and prevent a vacum from slowing the draining of the rad. your can also buy a flush kit from an auto supply store to help clean out your rad/engine if needed. Be sure and use the recommened coolant and ratios as per ypur owners manual when you put new coolant in.

Posted on Nov 23, 2010

Testimonial: "good advise-thanks"

Ad

1 Suggested Answer

Anonymous

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change thermostat in 1995 dodge ram 2500


drain the rad into a pail.
remove the upper rad hose from the thermostat housing.
remove the thermostat housing
remove the gasket/seal (from housing or engine)
remove thermostat

install ne stat & gasket/seal
reinstall housing and hose.

close off rad bottom valve
refill rad with new coolant (with cap off run engine until warm
top up fluid to neck) replace cap.

dispose of old fluid at environmental recycle center

Feb 11, 2015 | 1995 Dodge Ram 2500

1 Answer

How to replace a radiator on a 2003 mitsubitshi lancer es


make sure the engine is cold , drain the coolant from the rad ,there will be a drain tap/bolt on the bottom of the rad ,be sure to us a container to collect the fluid as should'nt be left to run down a drain etc as is very toxic,disconnect the top and bottom hoses, there are usually two bolts either side of rad loosen these, rad may lift out if not remove the bolts and lift the rad away and out of vehicle , if the cooling fan is attached to the rad remove , will be obvious what bolts need undoing, replace this fan unit on new rad ,then refit new rad , reverse of removal , dont for get to check the drain plug is closed on the new rad , refill cooling system by adding coolant to the expansion tank, run the engine and bleed the air from system ,there will be bleed screws at various points around cooling hoses etc , allow engine to cool 1 hour min ,check coolant level top up and repeat bleeding process as neseccary good luck very straight forward job , keep me posted

May 11, 2014 | 1992 Lexus Es 300

1 Answer

Overheating, loss of coolant, reservoir not working


Sounds like to me your mechanic is on the right track by having the rad cap changed. If the coolant becomes low again in the near future and there is no visible fluid leak on outside of engine or on floor/ground then your problem is internal and possibly a head gasket.

Jun 22, 2012 | 2004 Kia Sedona

1 Answer

How to remove hyundai trajet raditor


Hello first have a drain pan under the front under rad now open drain plug drain coolant ounce drain disconnect rad hoses and transmission cool lines use a strait head screw driver now remove the the bolts you see on top of rad usually 10mm size now lift out rad replace reconnect the bolts and hoses and refill the coolant and start engine let all the air bubbles burp out ounce coolant moves and rad fans come on top up coolant close off by putting rad cap on and check transmission fluid level add if needed you have now replace your radiator.

Jan 30, 2011 | Hyundai Motor 2003 Sonata

1 Answer

Where is the thermostate


On the tranny side for 3.4l. Follow the upper rad hose to the thermostat housing. You have 2 bolts to remove & the upper rad hose clamp.remove the air intake duct.Partially drain coolant.remove exhaust crossover pipe. Removebolts & thermostat housing. Next remove the thermostat. Clean both surfaces. Install in reverse order. Onthe 3.8l, it isagain at the end of the upper hose behind the engine mount. Good luck!

Sep 29, 2010 | 2003 Chevrolet Impala

1 Answer

2000 grand am se


Many things can cause this. It could be a slipping fan belt. This would cause the water pump to not pump enough water. Check the condition of the belt & replace if necessary. Also the water pump may be failing. The engine coolant may be low &/or leaking inside or outside the engine. Take the rad cap off when the engine is cool & check the level & start the engine & see if you cansee flowing liquid through the rad . No flow, bad water pump. Or the thermostat needs to be replaced, it may be stuck open or closed in your case. The thermostat is at the end of the upper rad hose & is removed by unbolting the thermostat housing after draining the fluid from the rad so it is low enough not to lose any. You may have a head gasket leak, ckeck to see if you notice any white residue on your oil dip stick & give the tail pipe the finger test &se if you can smell burnt antifreeze smell. Hope this helps. Good luck!

May 27, 2010 | 2000 Pontiac Grand Am GT

1 Answer

Good day sir, my radiator leaks coolant from under the radiator whenever i put on my a/c and it runs for a while. it started with the coolant bottle boiling & over flowing. please i need your help


hi sounds to me that your rad is blocked or sprung a leak first drain the rad and then refill with a rad flush run the engine for about 15 mins then drain be careful it will hot /when your engine is cool fill useing rad weild or another brand run this for another 15 min drain and refil as normal if this dose not work i think your looking at a new rad hope this helps if so please give me a rating best of luck pete

Nov 24, 2009 | 1998 Jeep Grand Cherokee

2 Answers

Dodge neon


drain coolant,follow upper rad hose to thermostat housing,undo hose,therm.cover,take therm.out,clean mating surfaces install new therm.and gasket.

Sep 17, 2009 | 1997 Dodge Neon

2 Answers

Putting in coolant


for a major fill- fill radiator not on hot eng let cool fille rad & & open vent valves on engine

Aug 29, 2009 | 1999 Pontiac Montana

1 Answer

Water come out from Water line when Engine Shutdown.


Does it show signs of over heating at all? When cool, take off rad cap & check level in rad & top it up. If down a lot, start engine, turn on heat & let run until you hear rad fan come on & check temperature gauge to see if normal operating temperature. Let it come on a couple of times, and top up rad an inch or so from top, then put rad cap back on. Top up bottle to proper level & try it. If it spits back into return bottle, try replacing rad cap.

Jun 06, 2009 | 2003 Ford Taurus

Not finding what you are looking for?
2005 Chevrolet Blazer Logo

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...