1995 Jeep Grand Cherokee Logo
Posted on Dec 05, 2010

When I start out 1st gear is fine but when it shifts to 2nd it goes back and forth, if I start in 1st manualy and get enough sopeed and put it in drive it will shift fine, fluid level is correct. 1995 Cherokee Laradeo auto trans

2 Answers

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 10 Answers
  • Posted on Dec 05, 2010
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Dec 05, 2010
Answers
10
Questions
1
Helped
1981
Points
27

Sounds like an internal pressure problem, check the oil condition(does it smell burnt and look dark brown ) if so get the transmission pressure checked at a garage and possible overhaul may be needed. Good luck big $ required.

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 1 Answer
  • Posted on Dec 07, 2010
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Dec 07, 2010
Answers
1
Questions
0
Helped
264
Points
1

Why sa dacef ha kila corm

  • Anonymous Dec 07, 2010

    you tula xilo?
    fac as no klpa

×

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Will not shift out of 2nd gear

Tranny most likely shot. I believe yours is a T-5, I had the same issue years back but in 3rd gear. Usually the clutch going out is a gradual thing. So I would have a tranny shop look at it. Maybe find a cheap rebuilt tranny for ya.Look online or a trusted shop.
0helpful
1answer

Lost 3rd gear and overdrive on my 92 crown vic

I have a 92 Crown Vic first and second works fine reverse works fine when it shifts in the third gear it goes to slipping and overdraft can you help me fix this problem thank you
1helpful
1answer

1999 3500 dodge 4x4 dually, 47re Tranny. problem existed before and after having my Tranny rebuilt. tried 4 new valve bodies even a new BD VALVE BODY. Truck starts out in 2nd gear when put into...

the transmittion keeps shifting in & out of gear between 45 & 50 mph it shifts to a higher gear then a lower then higher then lower till I get above 50 mph whats the problem & how to fix it
0helpful
1answer

1975 chevy blazer with a hydro-matic 350 automatic

check your kick down cable attached to the carb, it may be out of adjustment and forcing the trans to stay in "passing gear"
0helpful
2answers
1helpful
1answer

1998 Dodge Grand Caravan will not shif into 2nd

Most likely the second gear section of the transmission has gone bad. There are 3 or 4 different gear sections or assemblies in an automatic transmission, when they go bad, they go bad.
0helpful
2answers

Corolla 7a-fe tranny trouble

Have the tran fluid level checked
0helpful
1answer

We own a 2001 Dodge Ram 1500 4x4 with an automatic transmission at low speeds the transmission is shifting from 1st to 2nd gear back and forth and back and forth. Once you get it going fast enough to shift...

sounds like a valve body problem in the tranny first try some trans matic you can get it at auto zone if that doesnt help try a fluid and filter change in the tranny!!!!!!!!
0helpful
1answer

I have a 2002 Grand Am. Got the transmission checked and was told it's fine. It does not put out any codes and oil looked fine also. Around 3rd gear it feels to shift early. When I give it gas, it seems...

if your driving it normal your shift points should be from 1st to 2nd=18 to 22 mph
2nd to 3rd=28 to 32mph
3rd to od=48 to 50mph
these all change by how much throttle pressure is being use,
are you sure it's not fuel filter or plugs and wire surge your feeling
0helpful
1answer

Goes into neutral and then shifts hard into 1st on slowdown

It sounds like your input clutch seals are rolling. Is the check engine light on. It could also be the pressure control solenoid could be causing the problem aswell
Not finding what you are looking for?

274 views

Ask a Question

Usually answered in minutes!

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...