On the front of the shift knob you will see an area that has a metal clip, using a flat tip screwdriver pry out this clip as you pry it out you will see it is a u shape clip, once you remove this clip the shift knob pulls up and off. then just pull up on the center console cover where the indicators are at, this cover just snaps in, the bulb can be access
SOURCE: Need to replace boot sleeve on manual trans shifter
The frame that holds the "leather" in place just pops right out (come at it from one side; it'll sort of pivot around the other side -- I can't recall which is which, but trial and error works). Alternately, if you remove the six screws holding the entire center console in place, it can slide forward and rotate such that it'll clear the e-brake. Alternately alternately, if you curl your fingers underneath the boot frame on the side facing the rear of the car, you can pop the darker gray smooth plastic part of the center console entirely off while leaving the whole center console screwed in.
SOURCE: Chev Cavalier 2003 only one rear turn/brake/hazard light
I have a 2002 Chev Cavalier that had the same exact problem. I replaced the bulb harness (purchased from a chevy dealership for around $5) which was fairly easy to do. I have had zero problems with it since.
SOURCE: need instructions on how to remove center console to access electric window switch.
Here is what I could find, hope it helps.
Good luck.
Regards,
REMOVAL & INSTALLATION
See Figures 1 and 2
The following procedure is a general procedure for console removal. You may have to modify or skip certain steps depending upon your vehicle.
Fig. Fig. 1: Remove the retainers, unplug the connector, then remove the console door
Fig. Fig. 2: Exploded view of a typical console mounting
To install:
SOURCE: how do I release the belt tension pully to replace serpentine belt
You can run down to your local auto parts store and buy a serp belt tool. Or you can take a 3/8 drive ratchet, locate the 3/8 square hole in your tensioner and put the ratchet in the hole. For more leverage I put a deep socket over the ratchet handle and put a long 3/8 extention in the deep socket. This will provide ample leverage and will save buying more tools you do not need. Simply move the tensioner to the direction that takes pressure off of the belt.
SOURCE: console shifter light bulb replacement
you need to take your dash apart find out if the light is burnt out or if it not getting the signal
2,337 views
Usually answered in minutes!
×