SOURCE: i have a 2000 dodge caravan, no heat
Sounds like the air "blend" door might be inoperable. This door opens and closes a specified amount to regulate the amount of either cooled or heated air, as requested by the climate control unit. If the door is continually in the position which is bypassing the heater core (cold setting), the air will not get warm regardless of the condition/operation of the heater core. I'd suggest having this component checked.
SOURCE: Heater doesn't blow hot air
First check the coolant level in the radiator. Check your heater core hoses on the firewall underneath the hood. Let the car come up to temp. and feel the two hoses. If only one of them is getting hot you may have bad heater core or a bad heater control valve.
SOURCE: A/C/Heater only work and High and Heater does not blow hot air.
you can change the thermostat yourself for under 20 dollars. if you dont know how go to an autozone and they will assist you.
SOURCE: 2000 Dodge RAM no HEAT/ New heater core / AC evap.
There is a actuator on the right side of your leg while sitting in the drivers seat under the dash. It has a plastic rod for actuation manually actuate this diverter and should be the problem.
SOURCE: My heater in my dodge caravan does not blow hot
First of all make sure your anti-freeze is at specification level's as well as make sure With the engine cold start the vehicle remove the radiator cap and make sure you see the flow of anti-freeze while keeping your hands as well as your clothing away from moving parts feel both hoses going into your heater core if the one on top of hot one on the bottom is cold then you have a Clogged heater core in which case you will need to flush the system . a simple garden hose will do the trick simply remove Both hoses to the heater core with the hose at the bottom line apply the garden hose until liquid comes out at the top of the other hose will probably see a lot of gunk. Also ensure that the vacuum line to the round ball under the hood is connected and not dry rotted.this will cause a vacuum leak to not allow the switch to fully engage from cold to hot. I hope this helps you.
144 views
Usually answered in minutes!
×