The usual prob under the seats are the seatbelt pretensioner wiring the connector terminal pins tarnish and go high resistance putting the srs light on or the wiring has rubbed through on the seat movement parts the best way if you can not see a physical problem {disconnect the battery first before you look at the problem} is to get someone with a obd code reader that can communicate with the srs system to get a fault code out. BUT WARNING DO NOT MESS WITH SRS IF YOU DO NO NOT WHAT YOU ARE DOING IT CAN BE DANGEROUS BECAUSE IT USES PYRO/EXPLOSIVE COMPONENTS
SOURCE: srs light come on
hi,send your car to dealer to scan the problem,maybe erase fault is require ,or you can found the exact defective part,ty
SOURCE: CLK 320, the SRS light come on
Hi, There is a connector on the bottom side of the seat belt buckle. remove the rear seat bottom and check to see if the connector is damaged or just disconnected. The srs light has to be cleared using a scan tool.
SOURCE: SRS Airbag sensor light
Hey,
take a look at www.airbagmodul.com
They're working in Airbag-Simulators and Occupancy Sensor-Simulators.
Regards
Gerrit
SOURCE: W203 -how many yellow wires from B48 sensor?
Hey,
take a look at www.airbagmodul.com
They're working in Airbag-Simulators and Occupancy Sensor-Simulators.
Regards
Gerrit
SOURCE: I have a 2005 Mercedes C series. The front
Even thought the wiring might look ok unplug the the wires under the seat spray the plugs inside with some penetrating oil and try it again. that often works wonders
105 views
Usually answered in minutes!
×