SOURCE: tail lights not working while drive. brake,blinkers work
i have a crown victoria with brake lights no tail lights could you help me?
SOURCE: Engine will not turn over or start when in park with key on.
You linkage is working properly it sounds like, especially if the indicator for "D, R, N", etc are lining up. However the linkage or the neutral safety switch may need to be adjusted. More than likely, it's your neutral safety switch.
The brake pedal release has nothing to do with the neutral safety switch when switching gears.
The brake pedal release is just a safety to prevent you from pushing the gear shifter accidentally. Actually, you should be able to start the truck without holding the brakes.
If the neutral safety switch is bad or misaligned, it'll do exactly what you're describing. If pulling it down in neutral starts the truck, then that's a sure indicator.
SOURCE: parking lights and tail lights not working
I found out that if I pull the headlamp switch a little bit that the tail lights will then work for some reason
706 views
Usually answered in minutes!
fixed!, another fellow found a wire hanging by the brake pedal. Off the back of the brake on/off switch. Took 2 minutes to put back together, all is well in ford land!!
I put my foot on the brake, car is in park and I push the key in but i just can't turn it
×