2001 Saab 9-3 Logo
Posted on Jul 03, 2008

2001 Saab 9-5 Power Door Lock problem

Power door locks stopped working when using the key. Button on the center console does lock and unlock the doors. I replaced the battery in my key... still doesn't work. Any ideas? Perhaps a fuse?

  • 5 more comments 
  • Anonymous Mar 13, 2009

    2001 9-5 3.0 liter se wagon. Electric lock system will not function fron either the inside button control, or the remote key-fob control. Doors must be manually locked/unlocked

  • mhivon May 06, 2009

    trunk work, doors no, alarm system work well with remote

  • Anonymous Mar 14, 2014

    We went outside to grab something from our 2011 Mitsubishi Outlander and the battery is dead. We used the emergency key, but the doors will not unlock. Is there any other way to get in??

  • Anonymous Mar 18, 2014

    2004 model- cant unlock passenger dor at front, door locked closed

  • Anonymous Mar 27, 2014

    2006 model. Use 20A fuse had already changed more than 10 fuses during the last 3 months.. Please advise. Thank you. Leon Lee

  • Anonymous Mar 27, 2014

    Changed more than 10 20A fuses in 3 months. Problem not solve can someone please help. Leon

  • Anonymous Mar 30, 2014

    My power door locks stop working there no fuse

×

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

  • Contributor 2 Answers
  • Posted on Jul 21, 2008
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Joined: Jul 21, 2008
Answers
2
Questions
0
Helped
4009
Points
3

Does the key still pop the trunk/hatch? That would also indicate whether or not it was the key remote. If that function works it's probably nothing on the car (i.e. "receiver") end.

There is a very good SAAB forum that would likely be the best place to find out if somebody has has this issue before and what they have done: www.saabcentral.com

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a 2006 Saab 9-3. The remote stopped working. I have replaced the battery, but it will is not working.

You have to reset key to door lock. Hold key near door and press unlock for a few seconds. Should reset
0helpful
2answers

1999 saab 9-3 driver's side door will not lock

Sounds like the linkage came off, remove the door panel and inspect

If you need further help, I’m available over the phone at https://www.6ya.com/expert/edward_020b3320326d263d

0helpful
1answer

Manual key wont unlock saab convertible 9-3 07

Possible door lock actuator. Or you have a mechanical failure in the mechanism. Id remove door panel and inspect the mechanism but if you dont know what to look for, take to a reputable shop
0helpful
1answer

2004 saab arc driver side central lock not working

Check for a bad switch in the door.
Water leaking from the rag top-door seal joint often drains into the switch, causing a short or bad contact eventually.
4helpful
1answer

Step by step reset the door remote control lexus 400LS

1. sitting in driver seat, with driver's door OPEN, press lock/unlock button ON THE DRIVERS DOOR to lock all doors, then manually unlock driver door only.
2. Insert YOUR key in ignition, DO NOT TURN, then remove key.
3. Using the same lock/unlock button ON THE DRIVERS DOOR, slowly press lock-unlock in 5 cycles
4. Shut door.
5. Open door.
6. Using the same lock/unlock button ON THE DRIVERS DOOR, again slowly press lock-unlock in 5 cycles
7. With the door open insert your key into the ignition, turn to 'on' position (DON'T START), wait 5 seconds. Turn off and remove key.
8. Locks should cycle once (Car will lock and then unlock once by herself). If they don't cycle or they cycle more than once, do steps 1-7 over.
9. Now using the remote, push lock button, hold for one second, then release the button. The locks should cycle once. If not, start over and go slower.
10. Close the door.
11. Open the door.
12. Press the lock button on the remote. The locks should do a lock-unlock cycle.
13. Close the door
14. Press the lock button on the remote, the doors should lock.
15. Press unlock button and the doors should unlock.
0helpful
1answer

Un work of the doors auto control lexus

1. sitting in driver seat, with driver's door OPEN, press lock/unlock button ON THE DRIVERS DOOR to lock all doors, then manually unlock driver door only.
2. Insert YOUR key in ignition, DO NOT TURN, then remove key.
3. Using the same lock/unlock button ON THE DRIVERS DOOR, slowly press lock-unlock in 5 cycles
4. Shut door.
5. Open door.
6. Using the same lock/unlock button ON THE DRIVERS DOOR, again slowly press lock-unlock in 5 cycles
7. With the door open insert your key into the ignition, turn to 'on' position (DON'T START), wait 5 seconds. Turn off and remove key.
8. Locks should cycle once (Car will lock and then unlock once by herself). If they don't cycle or they cycle more than once, do steps 1-7 over.
9. Now using the remote, push lock button, hold for one second, then release the button. The locks should cycle once. If not, start over and go slower.
10. Close the door.
11. Open the door.
12. Press the lock button on the remote. The locks should do a lock-unlock cycle.
13. Close the door
14. Press the lock button on the remote, the doors should lock.
15. Press unlock button and the doors should unlock.

Long beep to follow if successful.
0helpful
1answer

Doors wont all lock at the same time on my '95 saab 9000cs. i have to manually lock them individually. My dashboard lights flicker, sometimes the lights will stay on and sometimes i have to tap the switch...

When you use your remote or insert your key in the Drivers Front door all the door locks should work at the same time by the door lock motors electrically. If you have to manually unlock the door because it will not lock or unlock by the lock motor, you need a door lock motor. The drivers and passengers front doors can unlocked with the key manually only. The rear doors you have to pull up the latch. 
If NONE of doors unlock electrically with the remote or drivers door lock, intermittently or all the time, you will need a Central Locking Electronic Control Module. Pressing the remote button you will hear the "beep", but no door locks will fire at all. 
If you have a few odd door locks not working intermittently or not at all, you will need a new door lock motor for each door lock that malfunctions. You can hear if the door locks are working electrically. Yes, they are common problem. 
If you can hear the door lock motor working but the door still doesn't unlock you need to take the door panel off and lubricate the door latch assembly and work the lock, loosening it up. This is common as well.
Sometimes a bad door lock motor can blow the central locking fuse. You will notice it because it will take a second or two longer to lock and unlock compared to the others. If the door lock motors seem fine, install a the next step up in amperage fuse. (From 15 AMP to a 20 AMP)
2helpful
3answers

2001 saab 9-5 electric door lock system does not function

Most likely you have a bad TWICE unit. it is located under the driver's seat, at a low point in the floor and often gets wet.
0helpful
1answer

1999 Saab 9-3 Turbo Convertible

you need to spend some time triing the best you can to get the top of the door panel open a bit to see what is broken inside, most likely a clip.The other thing to try is a slim jim to get the door open then repair the door lock.
Not finding what you are looking for?

2,533 views

Ask a Question

Usually answered in minutes!

Top Saab Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Saab Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...