There may be one on the thermostat housing. If not jack the van up higher on the cap side.
There's a bleed screw located at the bottom of the radiator. Open screw let fluid run out of radiator. Fill radiator with water run vehicle. Repeat above steps until fluid is clear. Use a coolant system flush. Refill system with appropriate amount of coolant and water.
SOURCE: 2000 ford windstar anti theft light flashing vehicle won't start
This means that your key is not being recogonized.Ethier the chip in the key is bad or the patts transciever at the lock cylinder. Do you have a spare key? If not you will have to get 2 new keyss cut and programmed.
SOURCE: My 2001 ford windstar lx van smells like coolant when i drive
Several things to check. Have the cooling system pressure checked. A quick and simple test. Puts system under pressure and helps to locate a leak. The coolant doesn't just go away, it's got to be leaking either externally or internally. Be sure that the radiator cap is checked too. It needs to maintain the proper pressure for the system
Sound like coolant is leaking on the exhaust system. This can result in the smell and you will not see a leak as it is evaporating when it hits the hot pipes.
Good Luck
SOURCE: i have a 2000 ford windstar no heat still
the problem (which is all to common on Windstar and Explorer) is the air temperture control blend door actuator motor is defective, this motor is what moves a door that gives hot, cold or a blend of hot and cold air blend to give u the desired outlet air temp.
SOURCE: 2000 ford windstar won't crank over,but pats keys good, and batt.
First thing I would check is to see if you have power at the trigger wire of the starter motor while someone is trying to start the vehicle for you. It will be a Yellow with a light blue trace. If you do then I would check to see if the main battery cable has power to it all the time when someone is trying to crank it. If it does then I would hold a test light on the case of the starter motor and have someone try to crank it. Make sure that the ground you use for this test is on the negative battery terminal not just anywhere on the car. If the test light lights while you are cranking it then you have a bad ground. Hook up a set of jumper cables from the battery negative terminal and clamp it directly on to your starter motor and see if it starts. If you check it and the test light doesn't light up and all the other checks are good then your starter motor has failed. If one of the other tests has failed then you have a starter relay problem or something else. let me know what you find out.
SOURCE: remove fuel pump from tank ford windstar 98
To gain access to the fuel pump, it is necessary to remove the fuel tank.
To install:
332 views
Usually answered in minutes!
×