WITH A GOOD FUSE TESTER, TEST ALL THE FUSES FUSEBOX UNDER THE HOOD & INSIDE THE VEHICLE. IF THE FUSES ARE ALL GOOD WITH THE TESTER YOU MUST HAVE A BAD BRAKE LIGHT SWITCH OR A BAD TURN SIGNAL SWITCH. THE BRAKE LIGHT CIRCUIT GOES UP THROUGH THE TURN SIGNAL SWITCH & THEN TO THE BRAKE LIGHTS. FIRST OF ALL IS THE BRAKE LIGHT SWITCH GOOD ? THE ORANGE WIRE FEEDS THE BRAKE LIGHT SWITCH, THE WHITE WIRE PUTS POWER TO THE TURN SIGNAL SWITCH, SO THE LIGHTS CAN BE USED AS TURN LIGHTS OR BRAKE LIGHTS. , PUT A TESTER IN THE WHITE WIRE & PRESS ON THE BRAKE PEDAL. IF THE TEST LIGHT LIGHTS UP, BRAKE LIGHT SWITCH IS GOOD, BY THE WAY THE BRAKE LIGHT FUSE MAY BE LABELED" STOP", THE FUSE LABELED" BRAKE" IS FOR THE ABS SYSTEM. TO CHECK THE TURN SIGNAL SWITCH FOR BRAKE LIGHTS, REMOVE THE PLASTIC COVER FROM UNDER THE STEERING WHEEL, PRESS ON THE BRAKE PEDAL, PUT THE TESTER IN THE SMALL YELLOW WIRE, THEN THE SMALL GREEN WIRE. IF THERE IS NO POWER IN EITHER WIRE, THE TURN SIGNAL SWITCH IS BAD.
This article was very helpful tracking down my brake lights not working with the third light working fine. I do have one more try this before you give up, because it happened to me. After you have checked all the above check your hazard lights switch. On mine if I wiggled the hazard switch back and forth I could make the brake lights go on and off with the brake pedal depressed. Hope it helps someone out there.
×
1,053 views
Usually answered in minutes!
×